Logo
FULL SITE MENU

Search results

  1. aristakat

    2016 honda 250hp low fuel pressure when first start

    Need help.. after my 250 honda sits for a day it struggles for fuel at first.. if i squeeze primer bulb seems to help..once running and fuel in motor no issues ? So only at first start .. any thoughts on what us failing ?
  2. aristakat

    Bbjj honda 250 2016 anode zincs

    Our there other anodes /zincs besides two on lower unit, and one under trim pump ? I know some motors have zincs anodes on block ?
  3. aristakat

    Happy Thanksgiving to all

    Just wanted to take a second say in past how thankful I was to have everyone on here Jamie
  4. aristakat

    parts diagram for 2016 honda 250 ?

    looks on net for diagram for parts 2016 Honda 250's any one know have a link ? also service manual ? do you think old 225 maual will work ?
  5. aristakat

    Honda 225 , ,, need help #3 fuse 10 amp blowing

    Okay guys need help number 310 amp fuse keeps blowing. .I have disconnected rpm/hour gauge,, tilt ,trim switch on shifter... still blows... I can run motor at high rpm or running in plane w no problem..once I run at idle speed it blows,, also will blow w switch turned on while motor is...
  6. aristakat

    Honda 225 , ,, need help #3 fuse 10 amp blowing

    Okay guys need help number 310 amp fuse keeps blowing. .I have disconnected rpm/hour gauge,, tilt ,trim switch on shifter... still blows... I can run motor at high rpm or running in plane w no problem..once I run at idle speed it blows,, also will blow w switch turned on while motor is...
  7. aristakat

    need info on a serial number for honda 225

    Can someone find info on a 2007 Honda 225 such as is service bulletins have been done ie #56 etc..for me ? serial # bagj-1403788 thanks Jamie email is [email protected]
  8. aristakat

    Honda cowling not locking ?

    Ok need help , my top cowling on right side won't click or latch. I took middle cowling off to see it...I can see it's not cable, seems the tension arm that spring over to catch Latch might need a new spring ? Anyone ever had this issue ?
  9. aristakat

    need some help on 2002 honda 225

    ok ran motors out last week noticed one motor jumping/losing power... I feel like its starving for fuel/// I just changed all fuel filters ...runs fine low or normal rpms.. Only when I thortle fully does it act up on one motor ? any diagnostic help appreciated thanks Jamie
  10. aristakat

    honda 225 2002 need help motor seems to be starving for fuel or surging

    Replaced filter all replaced HP pump Cleaned vst tank Surges under load Pulled lap pump didn't see anything wrong Seems like fuel bulb gets soft when pumped motor runs better Any suggestions where to look ?
  11. aristakat

    here we go again bf225 honda 2002

    Hearing a intermittent clunking/thunging sounds.. Trying listening to w a tesascopecw local Mechanic.. he States could be a broken/loose pin connecting piston to connecting rod.. Or could be a bad bushing on connecttingrod.. Called two mechanics they both weeks out before can look at.. Any...
  12. aristakat

    hona 225 2002 cold start issue

    ok all would like some imput when I put boat in water starboard motor starts but fuel line doesn't prime up .. so I start motor while running I squeeze primer bulb till gets hard then all is fine ..my port motor has no issue like that .. what could be problem ? this motor had fuel pump...
  13. aristakat

    impeller change surprise

    Changing impellars today look what I found
  14. aristakat

    honda 225 2002 need help stripped screw ?

    ok need your help again guys went to change the high pressure fuel filter when pulling out the 3 screws the top screw started stripping hard to reach any suggestion how to get the screw out. Can't get impact driver to reach, how hard is it to pull entire fuel strainer off ?
  15. aristakat

    need a little imput on my 2002 225 honda stalling out at first start up

    okay guys what do u think I have twin Honda when I first start port one a ramp in neutral she reves , I squeeze fuel bulb seems a lttle soft , once I back off trailer or engage in forward she stalls . Now if I engage in forward fast and throttle up fast she seems to do fine. On this motor...
  16. aristakat

    do I need special oaint for gearcase

    OK pulled lower units primed w zinc chromate , Can I use titanium silver to paint gearcase ? Then will clear coats after ? Last time painted w car paint didn't last long Thanks
  17. aristakat

    look alikes saw them at boat show yesterday

    http://features.boats.com/boat-content/2013/10/hot-news-from-tohatsu-new-250-50-hp-outboards/ Saw both at Miami show one was black other was silver other then that looked same ... Anyone got input on them tohatsu wanted more $$ then Honda that surprised me
  18. aristakat

    gearcase oil reccomendation honda 225 - 2002

    OK guys need input was told other day could get gearcaseoil at local nNapa dealer no name version.. I chose west marine purchased quicksilver high proformance gear oil instead.. was curious what others use/ recommend ? Thanks in advance for feedback
  19. aristakat

    relacing shift shaft oring /oil leak

    Ok need help again havent researched manual yet but have oil leak been told it is shaft shaft oring .. I am told have to pull bottom half off all the the way to midsection,, then pull power head off to get to oring.... 1. Heres question anyone had to do this and how extensive is it to pull...
  20. aristakat

    nonda 225 2002 not running

    Ok all need imput again : port motor honda 225 yr 2002,,, died as running idle from one spot to next brought to mechanic to trouble shoot. check fuel from tank to motor,I replaced hp filter,racor inline filter, replaced squeeze primer bulb.... had fuel coming from tank to motor pulled line to...
Back
Top