Logo

Search results

  1. haffiman37

    Fuel pump diagram

    This should cover your question:
  2. haffiman37

    Marine Gauges for 1989 110 Johnson 2T

    Too much instrument lights and you loose your night vision. Best is to have the light red or green dimmed down. Here a pick of the old Tech series Volt gauge: Rev counters are 3", the rest 2".
  3. haffiman37

    Steering - 1989 Johnson 110HP 2 Stroke

    It is called: Water pressure instrument. It is measuring the waterpump pressure. Simply install a plastic T on the pee hose, pull one hose to the instrument. It makes you keep a check on the impeller, might tell you if thermostat valves are not functioning properly etc. Low water pressure on...
  4. haffiman37

    Steering - 1989 Johnson 110HP 2 Stroke

    Your Bezel is the 90 degree round alu part mounted on your dashboard with 4 screws. The helm is held in place in the bezel by a round nut with 2 or 4 slots and normally need a special tool to remove. (Teknoflex who made this, normally supplied this tool with the helm kit). However corrosion...
  5. haffiman37

    tele flex volt gage wireing hook up.

    I guess this is the set-up you have: If you hook your meter up to 'C' it will read whichever battery is 'connected' to 'C' at the moment. However if you have separate circuits for start and consumption (one battery for each purpose) with a charge splitter/diode, situation get a bit different...
  6. haffiman37

    Ad 1991 41 fuel pump leak

    Re: Ad 41 fuel pump leak Go to: http://www.marinepartseurope.com Click your way to your engine, fuelsystem and injection pump. There you get an exploded view and parts diagram.
  7. haffiman37

    Need Help with 20HP Johnson

    No ned mod number or year, all the same: DRIVE PIN 0307949 List Price $1.05 Part Number 0307949 Johnson 0307949 Evinrude 307949 Johnson 307949 Evinrude...
  8. haffiman37

    D1-30 heat exchanger/exhaust manifold

    Use this as a rough guide:
  9. haffiman37

    2 cylinder inboard yanmar engine

    It is an 'anti siphone valve' and may prevent the water from filling the exhaust system and entering back into the engine when sailing. Usually a rubber membrane inside that may have broken. Not a typical Yanmar part, any valve from Volvo, Vetus etc may do.
  10. haffiman37

    1994 j140txarc

    Thank you Daselbee. When finished the idle setting, you may even perform a balance check of the engines 'lower' condition. When running smoothly at idle, or if not running smoothly at one or more cyl, use a carb synch tool. Equal plunger lift on all carbs and idle mix screw at same setting...
  11. haffiman37

    WOT surge Johnson 150 Faststrike

    Check vapor chamber lid, seals and filter for air-leaks.
  12. haffiman37

    Posting pics

    "Posting pics on the forum is "Posting pics on the forum is to some a problem due to size of original. My suggestion, and the easiest one is to install: Shrink Pic. Here: http://www.onthegosoft.com/shrink_pic.htm This automatically reduces all posted pics, e-mail attachments etc to a...
  13. haffiman37

    Merc 603 cyl 2000 No spark

    "Above motor has lost its spar "Above motor has lost its spark. Anyone got the readings (ohm/Volts) from trigger and stator? Got no books and diagrams, just a messy motor with a lot of loose wires, 4 'gray' coming from trigger, 2 green/white from stator."
  14. haffiman37

    Just the top or the whole drive

    "I see it again and again, and "I see it again and again, and I get slightly 'annoyed' each time it is recommended only to remove the top part of the drives to change the bellow. In my opinion, has the drive been on for such a period of time that the bellow need to be changed, remove the whole...
  15. haffiman37

    Cowlign Seal 332876

    "I guess a search on the BRP s "I guess a search on the BRP site with correct Model number as reference will give the answer. Parts for old models gets modifies all the time to fit as many as possible. Only an up-dated dealer may give the exact answer, I'm not anymore. However I've no memory of...
  16. haffiman37

    Fuel pump

    "Try this link http:/ "Try this link [url=""]http://epc.brp.com/DEFAULT.ASPX?BRANDS=EJ&LANG=E&DEALERLOCATOR=NOink: Just follow the instructions and You will find the parts for the VRO"
  17. haffiman37

    Omc sterndrive clutch dog and prop shaft removal

    "I 'refreshed' my mind "I 'refreshed' my mind and went into Dougrussel.com. Unfortunately they only have from 1983 catalog in the OMC section, but take a look. I'll try some more search tomorrow, it is 1.15AM at my location! Need some sleep!"
  18. haffiman37

    Off topic Server problem

    Andrew: Your server seems to Andrew: Your server seems to be on vacation or partly sick leave. Any time frame when it will be up and running again?
Back
Top