Logo
FULL SITE MENU

Search results

  1. M

    150xp water pump

    1988 Evinrude 150XP E150STLCCA When I torque the water pump housing down to the specified 7-9 Nm the rear of the housing is not flat on the SS base plate. You can see the irregular shaped O ring between the plastic housing and the SS base plate. When I remove the housing the O ring is still set...
  2. M

    150XP electrical

    Original problems: Tach not reading Voltage gauge reading about 11 volts with good battery What I've done: New Wiring Harness, New Reg/Rec, New Stator. Cleaned all battery, starter, ground connections plus a few others Results...
  3. M

    150XP electrical

    Ordered a new Reg/Rec today as well as a new water pump as per "faztbullet" recommendation. After pulling the flywheel and stator to remove the Reg/Rec I noticed a lot of "Black Goo" coming from the back of the stator and also some "amber colored hard substance" that melted, dripped and...
  4. M

    150XP electrical

    1988 Evinrude 150XP, E150STLCCA Motor runs well but tach not working and voltage gauge reading 11 volts with good battery. Use to read 17 volts. I have: Connected grey wire (for tach) to yellow/grey stator wire at terminal strip (per Joe Reeves) and tach will work. Although it reads...
Back
Top