Logo
FULL SITE MENU

Search results

  1. K

    1990 evinrude 120 cuts out

    I have a 1990 evinrude 120 that has not been run in 7 years Put new plugs , impeller, t-stats , and linked and synced carbs Motor runs great but overheats and alarm goes off after 4-5 minutes above 4000 rpm Keep it below 4000 rpm and it runs all day without overheat Only the starboard head...
  2. K

    1990 evinrude 120 link and sync

    What kind of timing should i be looking for at idle of 700 rpm + or - Or Should I not be concerned with idle timing as the manual does not actually list a degree setting for idle . Just do link and sink and it should be OK ?? Manual only gives WOT timing , which is 18 degrees in chart in...
  3. K

    1990 evinrude 120

    How can you tell if a motor has the quick start feature that advances the timing to help start a cold engine ??? How does it work / activate advance ??
  4. K

    1990 evinrude 120 water control valve delete

    Does anyone know exactly which parts are required off which year and model evinrude to replace what is needed to delete water control valve ? do the covers , and stats need to be replaced with different ones along with the springs and diaphragm's ? I've read several post and each gives different...
  5. K

    1990 evinrude 120 link and sync

    Does anyone know of a video showing lync and sync for a 1990 ev 120. The Clymer manual is a little hard to interpret. Also , can the WOT timing be done with Joe Reeves method out of water on this engine , and if so what WOT advance should i set at to compensate? Actual advance calls for 18...
  6. K

    1990 90 hsp evinrude rebuild

    just finished installing rebuilt PH . Fired up and ran excellent , but water was gushing out around the bottom front of the cowling. I could look up in the cavity, just in the front end of the exhaust housing and after starting the engine , about 2-3 seconds later water was just gushing out ...
  7. K

    1990 90 hsp evinrude rebuild

    how do i know which gaskets require gasket sealing compound and which do not Obviously , the crankcase gets sealer , but , more specifically , what about the intake manifold and the exhaust housing . And , what sealer , if needed , is preferred on those two I had planned to use the normal...
Back
Top