Logo
FULL SITE MENU

Search results

  1. T

    1998 Mercruiser 350 Mag MPI fuel line

    So I have a fuel line that was chafed by the hose clamps on my raw water pump. I ordered a replacement at $160 but who knows when it will ship, if at all due to "special order". Anyone have an alternate solution for this fuel line? Engine serial is 0L006710 Part is 32-807953
  2. T

    360 harmonic balancer diameter?

    Anyone know the diameter of the harmonic balancer on the 360's? I need to make a timing tape. :)
  3. T

    Replacing Prestolite distributor?

    What are people swapping to from their old Prestolite distributor? I"m chasing a spark problem (that started out as just hard starting and now it WON'T start at all) thats looking more and more like the reluctor and sensor (anyone know what the resistance should be on that? When I tested it at...
  4. T

    2002 Mercury 15hp skipping

    Working on a 2002 15 2 stroke, cleaned the varnish out of the carb from sitting for quite a while, threw new plugs in it. Running it on fresh fuel it doesn't really like idling much (if i hold it to a slightly high idle its fine), when you rev up slightly to high rpm, it will occasionally skip...
  5. T

    Aftermarket geared starter P/N for Chrysler 360s?

    Anyone know what starter replaces these stupid ones? https://www.marinepartssource.com/starter-arco-50110 I'd like a bit more oomph that doesn't beat batteries to death.
  6. T

    Oil pressure sender Marine 360

    Is there a particular single station oil pressure sender needed for 360s? Googling doesn't really turn up much other than 5 different senders, if I had to guess its just a generic 80 psi one wire sender with 1/8" NPT like this...
  7. T

    360 cooling system (closed cooling)

    So on the starboard engine, the starboard manifold has a metal tube running from the bottom/rear of the manifold going forward to attach to the cooling system. But the port manifold does not have this, it just goes to an elbow and directly to cooling hose. Is there any need for this tube other...
  8. T

    Fuel filters for 360's

    P/O had 2 micron racors in line from the tank to the pump right now. This seems a bit over the top, is there any reason to stay with 2 micron or are 10 micron fine? (10 are cheaper and way easier to find)
  9. T

    360 temp sender??

    Anyone have a P/N? I wasn't able to cross reference out of the original manual.
  10. T

    360 oil/oil filters/remote oil filter mounts

    I know I'm opening a can of worms, but what are people running in their engines? My twins I have no clue what was being run in them given the P/O basically knew nothing about the boat other than what the yard it was kept at "told" him. (Some of the bills he paid are pretty silly) Anyhow, I see...
  11. T

    Chrysler 360 overheating issue

    I'm stumped. FWC motors. 1 runs at 150-160 idle, risers are around 105/110 Other Would slowly just climb up and up and up. I pulled the thermostat and ran it sans thermo now it runs 150-160ish The odd part is the risers on the hot motor were about 5-10 degrees warmer with the port riser...
  12. T

    Chrysler Marine 318-360 manual

    Hey all, Does anyone have a copy of QMAR318-360.pdf they can share? The site it used to be on seems to be long gone. Thank you!
Back
Top