Logo
FULL SITE MENU

Search results

  1. S

    Idle Runaway, New Cam Follower Roller installed

    I have a E200TXECM that I was having low idle problems with. Took advice from forum and mech. Replaced enth fuel with reg gas, replaced #1 plug coil and put on a Cam Follower Roller, which was missing to start with. Now when I run it , it idles fine for a couple minutes, then the idle starts to...
  2. S

    Low idle peoblem

    I have a 1996 Evinrude E200TXECM that I am having low idle problems with. It cranks and idles in neutral, but when you go to take of , it stalls. You have to very slowly get to 1/4 throttle and then give it all the throttle and back off. Also it is hard to trailer because it keeps dying while...
  3. S

    Tilt and Trim

    I have a 1998 E200TXECM 200hp outboard. tilt/trim button seemed sticky so I worked it a little. Next morning motor was all the way up. Did manual release to trailering hold. Hydraulic fluid is full, tilt motor runs but nothing happens. Retightened release screw. Trim cylinders are in the up...
  4. S

    Lower exhaust housing and lower unit

    I have an E200TXECM that I just rebuilt the waterpump on and when I went to take it apart, I noticed a small gap between the two housings. It has been a while since I have done this , and never on an outboard this size. When I put it back together it fit the same way with the gap, and has small...
  5. S

    Tilt/Trim Plug and screen 198 200hp

    I have a E00TX00ECM and the plug and screen has broken off, part number 0337530 or 337530. I need to know how to get the remaining piece out of the mount. Does anyone know the size of the piece that goes into the mount. I'm pretty sure an easy out would do it, but don't know the correct size.
Back
Top