Logo
FULL SITE MENU

Search results

  1. C

    1990 Mercury 9.9 HP 2 stroke Electric Start (Tiller hand start) running problem

    I finally detected no spark problem with this engine. It is a short in somewhere in the stop/kill switch. So, I disconnected the Black/Yellow wire from the Laynard stop switch and got the spark back. I then proceeded to run the engine: started with full choke then let it run without choke. It...
  2. C

    Crusader 220 Raw water pump

    On my starboard engine the raw water pump does not pump the water out. A few days ago I opened the pump and checked the impeller and it looks like new. I put it back together and checked the pressure by hand and it seems to push the water out (maybe). I also tested the flow from the inlet...
  3. C

    1999 Mercury 9.9HP, 2 Stroke, Electric start on tiller, S/N 0B216641

    I have a 1999 or 2000 Mercury 9.9HP S/N 0B216641, 2 stroke with electric start on tiller arm. The engine turns when start button is pressed but no spark from either plug. Plugs are new and I use inline tester for spark test. Makomark suggested that the problem could be with Trigger Assembly or...
  4. C

    Mercury 9.9 HP 2 stroke, s/n 0D216641

    I cannot start my little 9.9 HP Mercury engine, I can crank the motor with electric tiller switch but I am not getting any spark with spark tester. The Lanyard switch works fine, tested with continuity tester in On/Off position. Wiring diagram here (MarineEngine.com) shows a 20 A fuse, but I...
  5. C

    Binding bendix on Crusader 220 engine

    Hello Guys, I just replaced my port side engine, after the old one locked up on me couple of months ago, and I tried starting it up today with a remote starter switch, however, I am having the old problem revisiting. The starter bendix will bind on the fly wheel and want let it go unless I shut...
  6. C

    Replacement of 1988 Crusader 220 (Chevy 305) with 1988 Chevy Silverado 305

    Hello Guys, I am in the process of replacing our port engine, 1988 Crusader 220 (Chevy 305-5L) and I have found in our vicinity completely rebuilt 1988 Chevy Silverado engine with throttle body injection TBI intake manifold, not for carburetor. The Silverado engine has new camshaft and...
  7. C

    1988 Crusader 220, twin engines Chevy 305

    After the harness re-wiring was completed I wanted to do the dry crank on left engine. Prior to this point I tried cranking this engine two weeks ago but could not move the fly wheel with a starter, instead the starter was locked and the humming occurred causing the battery terminal to smoke. I...
  8. C

    Instrument panel Wiring Diagram for 1988 Chris Craft 220

    I need to get wiring diagram for 1988 Chris Craft Instrument Panel/Control Board to rewire all switches, nav. lights and gauges from fuse blocks. The existing command board wiring is a nightmare and I need to clean it up and rewire. I have twin Crusader 305 engines and this boat has been stored...
  9. C

    Clicking noise around starter

    "On my Crusader 220 I recently "On my Crusader 220 I recently replaced motor starter and solenoid. Everything worked OK for a few times then she could not start anymore. I am hearing clicking sound from the starter area. At first I thought it was a battery, then I switched cables to the second...
  10. C

    Windlass anchor problem

    "Hi Guys, On my 1988 Chris Cr "Hi Guys, On my 1988 Chris Craft Catalina 292 I have a windlass anchor made by Rankey Winch Co. Just recently it stopped working. So I replaced the two 5 terminal solenoids, continuous duty, and no improvement. I did open the motor and brushes seem to be like...
  11. C

    Crusader 220305 CID

    "My left side engine starts an "My left side engine starts and runs good up to 2000 RPM. When raised to 3000RPM it drops back to 2000 RPM. I suspect the carb problem but don't know what. I had similar problem months ago. Carb was rebuilt and problem was solved, or was it? We don't take this...
  12. C

    Starter

    "My left side engine, Crusader "My left side engine, Crusader 220-305, had always the problem starting before. I had to pump the gas several times before it would fire. Yesterday, the starter gave up on me. I thought it was battery but when replaced I got the same clicking sound from the...
  13. C

    15 HP Johnson 1998 4 cycle

    "I have a 15HP Johnson 4 strok "I have a 15HP Johnson 4 stroke that has a remote throttle and shift controls. My problem was that when installed the new cables I did not rig it properly and I cannot get the higher RPM in Forward gear. As I move the shift down (forward) the speed will increase...
  14. C

    Circuit Breaker for Model 220305 CID

    "I have experienced engine cut "I have experienced engine cutout, after several RPM drop offs, and I suspected the culprit may be the circuit breaker. I am not sure, but the left engine would run at high speed (3200 rpm) for a while and then the rpm would suddenly drop, rise back to the set rpm...
  15. C

    Loss of power at higher speed

    "On my second Crusader 220 eng "On my second Crusader 220 engine I have experienced sudden loss of power at about 3000 rpm, at about 11 knots speed. I noticed earlier that my oil pressure gauge was reading at neutral 25 psi, while the other engine was showing 55 psi. I changed the gauge and...
  16. C

    Crusader 305

    "Hi, After Quadrajet Rochest "Hi, After Quadrajet Rochester carb overhaul, on my RH Crusader 305 engine, I am experiencing loss of power at high RPM. It does not last long, but it happened 7 or 8 times at the speed of 3000 rpm on a route of about 10 miles. I thought the high speed screws...
  17. C

    Water in fuel

    "I have 2 crusader 305 engines "I have 2 crusader 305 engines which ran fairly good every time I started. The last start up was three days ago when I ran them for about 5 minutes each in the dock, at idle. Boat has been in the dock for the last two months because of the repairs/replacement of...
Back
Top