Logo
FULL SITE MENU

Search results

  1. K

    EdelBrock Marine Carb 1409 for sale

    I've listed this today - figured if anyone needs one - http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&item=201180919291
  2. K

    360 Engine Temps.. plus thank you

    First I'd like to thank the regular contributors of this board. The knowledge you share really helps and is appreciated. I've learned alot from this board. My question is - I've seen a 10 degree increase on both my port and starboard engines pretty much at the same time when running at 3k...
  3. K

    New Gauges

    I'm looking to replace the RPM, Oil Pressure, and Volt gauges for my 360 engines. What do you recommend? Thanks!
  4. K

    No power to gauges or ignition switch

    All of a sudden my port 360 cut out - no power to gauges or ignition switch. I checked the neutral safety switch, and that tested fine. Battery voltage is fine. Any ideas?
  5. K

    Port stalling

    Ran into an issue - Port engine running fine for 15-20 minutes cruising at 3000rpm. Bring power back down for no-wake zone to 1000rpm and engine stalls. Fires right back up fine, runs for a few minutes then stalls again. Looking at the volt meter, it's reading 14 volts when I left the dock...
  6. K

    360 stall

    Yesterday, throttled down from 1500 RPM to 1000 RPM, engine stalled. Fired right back up. 10 minutes later when docking, shifted into reverse, stalled again but fired right back up again. Where should I start? Engine runs smooth - no other issues noted. Would a bad coil or bad ECM cause...
  7. K

    Operating temp of 360

    What would be the average operating temperature of a full fresh water Chrysler 360 operating at 3,000 RPM?
  8. K

    White smoke for the first minute or two after cold start

    I'm getting some white smoke that I never had before - for just a minute or two after a cold startup. Engine is a 360 reman that is two years old. Any help would be greatly appreciated. Thanks guys.
  9. K

    Battery question

    How do you have your batteries wired? I have two Chrysler's each wired (along with the charger and alternator feed) into ports 1 & 2 respectively (which are also connected to each battery bank) on a guest switch.
  10. K

    RPM drop

    Today I noticed a slight dip (200 rpms) on the port engine when running at 3,000 rpm. I happens every 10 seconds or so just for a quick second, and recovers. No noticeable difference in power or sound. Any ideas?
  11. K

    Clicking noise on 360

    I've developed a clicking noise on my starboard engine. It changes from slow to fast as you throttle up. The engine also sounds "deeper" than it did in the past. The clicking and deeper sound both happened at once. It's operating fine. No loss in RPM or erratic behavior. Any thoughts?
  12. K

    360 quit!

    Cruising along on my 33' Egg, and all of a sudden the starboard engine quit. Temp/oil pressure was fine. Checked/replaced Ignition coil and fuel/water separator - Nothing. I can occasionally get it to start for a few seconds, but that's about it.... Where should I start?
  13. K

    fuel/water separator

    I'm replacing my fuel/water separator myself for the first time going into my Chrysler 360's. Any tips? Should I fill the canister with fuel before reinstalling? Do I need to vent the top after starting?
  14. K

    Alternator for 360

    Hey guys - Can you lead me in the right direction for a replacement alternator for my 360? Is this the right one? http://www.carolinaboatoutfitters.com/catalog/product_info.php/chrysler-marine-alternator-61-amp-40112-p-76686
  15. K

    Oil Choices

    What type of oil do you guys recommend for a Chrysler Marine engine on a boat that's in the water from May-October? Right now I'm using 5W-30, but heard with the flat tappet engines, you need to add a zinc additive.
  16. K

    Rotation question

    I'm ordering a new engine for the PORT side of my Egg Harbor (360 Chrysler). The company I ordered from said that I needed a reverse rotation engine, due to the type of ratio on the transmission. Does that sounds correct?
  17. K

    1800runsnew.com

    Anybody have any feedback on 1800runsnew.com? I called them for an engine this week, and they seemed very good at what they do.
  18. K

    Overheating issue driving me nuts!

    OK guys, here's the issue. I have 1977 Egg Harbor with 360's and the port engine overheats after running at high RPM. Engine will run perfect at 160 degrees at the dock and around the marina, but as soon as I throttle up for an extended period of time, upon throttling down, the engine will go...
  19. K

    looking for 360

    I'm looking for 1 Chrysler 360 or a pair of 318's in working condition if anyone knows of any that are out there.
  20. K

    Cooling issue

    I have Chrysler 360's - port engine today shot up to over 200 degrees. I quickly shut down and found about a gallon of coolant in my bildge. Had a ton of air in the coolant system.... Filled again and ran OK...any ideas? Could a t-stat stick?
Back
Top