Logo
FULL SITE MENU

Search results

  1. B

    1994 Force 40hp - How to check timing?

    Motor: 1994 Force 40hp (serial # 0E067660) I have a service manual but it does not have any information about checking if the timing is correct. Could someone please help point me to the right resource as I am sure this question has been asked before. FYI -- I did search the Force motor forum...
  2. B

    1994 Force 40hp What is this hose?

    Motor: 1994 Force 40hp (serial # 0E067660) Please let me know what this hose in the picture is for? I goes from the starboard side all the way to the port side and then hidden behind a bunch of electrical stuff. I wanted to replace it because it has some cracks but I didn't want to mess up...
  3. B

    1994 Force 40hp Idle Speed Adjustment

    Motor: 1994 Force 40hp (serial # 0E067660) I bought the service manual jerryjerry recommended and am trying to adjust the idle speed. The idle is high so I turned the screw counter clockwise to lower it. However, it has no effect because the linkage on top is holding it in place (please see...
  4. B

    1996 Evinrude 60 hp - Why won’t it start?

    Please help me troubleshoot this. I recently picked up a non-running 1996 Evinrude 60 hp and am trying to bring it back to life. I have done the following: 1) Replaced water pump 2) Clean carb twice to make sure 3) New spark plugs and spark jumped a gap of 1/2” 4) Compression is between 135...
  5. B

    1994 Force 40hp Impeller Replacement HELP !!!

    Hello Pros, I inherited this motor, but unfortunately the water pump assembly was ALREADY removed when I got it and I am trying to put it back the way it was supposed to be. I am stuck at this point because: 1) I cannot slide the drive shaft down far enough for the pin to lock against the...
  6. B

    Cam follower adjustment for 1991 Johnson 25 HP (J25TELEI)

    I need help with adjusting the cam follower to sit between the two marks on the cam. Below is a picture of the instructions from the service manual. However, that procedure only allow the cam follower to touch the cam (or not). I can't move the cam follower back and forth to sit between the two...
  7. B

    Is this a bad fuel pump for sure? 1991 Johnson 25 HP (J25TELEI)

    Hi all, I have been suspecting that the fuel pump is bad. Please watch the video below showing my motor running. https://youtu.be/k5HAxkuvYQQ
  8. B

    1991 Johnson 25 HP (J25TELEI) Fuel Issue

    Hi all, I recently bought this motor and am currently troubleshooting a difficult start/idle issue. I have noticed that gasoline is pooled under the carb and don't think this is normal. If this is not normal, what is the likely cause of this? Thanks.
  9. B

    1974 Johnson 25hp [25RL74M] Throttle Adjustment

    Hello everyone, I have searched everywhere but unable to find a step-by-step guide to set the carb throttle to original factory specs for my motor (1974 Johnson 25hp [25RL74M]). After installing the Ignition Tune-Up Kit (0172523) and the Carburetor Kit (0396701), I thought this was a piece of...
Back
Top