Hi,
I have a rebuild kit, but am unsure which are the driveshaft seals for the upper unit (Gen 2 so the seal go in from above, not from underneath as they did in Gen 1). From memory of what I pulled out (I forgot to take a pic) I think it was the two that are the same height (put in back to back), but I also have a single slightly higher one of the same diameter, and it looks like there is enough room to accommodate that height. Parts diagrams and service manual are not clear.
Also, the service manual says to use the seal insert tool to space it correctly, but as I recall the seals were up against each other with no gap?
I have a rebuild kit, but am unsure which are the driveshaft seals for the upper unit (Gen 2 so the seal go in from above, not from underneath as they did in Gen 1). From memory of what I pulled out (I forgot to take a pic) I think it was the two that are the same height (put in back to back), but I also have a single slightly higher one of the same diameter, and it looks like there is enough room to accommodate that height. Parts diagrams and service manual are not clear.
Also, the service manual says to use the seal insert tool to space it correctly, but as I recall the seals were up against each other with no gap?