Logo
FULL SITE MENU

Recent content by zigzag03

  1. Z

    3GM30F Fuel Filter

    20yo 3GM30F, want to replace the Racor pre-filter. Currently has a brown 2 micron element, and this seems small to me. I know the Volvo Pentas call for 30 micron elements on the pre-filter. Been reading what I could find for manuals, not seeing a recommendation. Anyone have a recommendation, or...
  2. Z

    240G Beep codes

    240G in a 2016 21' Chap with SX drive. Emissions motor. Beeps once every 10 sec. One manifold/riser noticeably warmer than the other. Can anyone interpret that beep for me? Does it have, like the Mercs, a water/block pressure sensor somewhere? Manifold temp sensor reacting to the hot manifold...
  3. Z

    HPDI help please

    I have an 04 200 HPDI that doesn't pee. I've been from the back of the exhaust plate, thru the voltage regulator, and out the pee tube and found no blockage. It doesn't seem to be overheating, and it has a water pressure gauge fed off the top of the port cylinder head that gets up to about...
  4. Z

    Late 90s 175 carb ignition question

    No spark rh bank. Testing stator, resistance is perfect, then testing output (dva) at outer switchbox numbers are good, inner both red and blue show about 15v. Take those wires off that inner switchbox and son of a gun I get nice output, in spec, matches other SB with wire connected. Is this a...
  5. Z

    350Mag MPI help me work thru this please

    I have the above mentioned engine 0W666xxx, as clean and pretty a 13 yo engine as you'll ever see, and here's my problem. Fuel injectors 5,6,7,8 don't fire. Using a DDT, I cylinder drop all eight and those four don't drop. I load test the injectors, and the back four, two either side, don't...
  6. Z

    Old V6 Idle speed controller

    Does anyone know if the idle speed controller on a 175 can kill the entire ignition system? I have the three screw style that bolts atop the port cylinder head. And what about the mercury tilt switch mounted just above the power packs, I don't remember how it functions, could it kill the...
  7. Z

    Trim/tilt on 2015 DF70

    I have a late model DF70 that t/ts fine from the control handle but not from the cowl. A quick prob shows no power to the switch at its plug. Power jumped to either side makes it tilt thru that harness and an ohmeter confirms the switch is fine. Sooooo, white wire with red stripe should feed...
  8. Z

    115 hp ficht 2001 injector oil leaks

    this otherwise fine running motor with a couple hundred hours on it leaks what i would call dirty oil from the two bottom injectors, making a mess in the lower cowl and running down the leg if left vertical. it clearly comes from the area just below where the injector seats on the head. i popped...
  9. Z

    350 mpi fuel filter

    "anyone got enough experience "anyone got enough experience regularly servicing later model crusaders to tell me whether the primary fuel filter (nearly $100 list) is changed at the 100 hour interval, or at all? the filter in question looks like no other filter i've seen, sort of pancake-shaped...
See more
Back
Top