Logo
FULL SITE MENU

Recent content by xsplicer26

  1. X

    Fuel Pressure Problem

    My 2006 Honda BF 225 started giving me trouble toward the end of last season. After trolling for some hours, when starting to rev up to make a move, the engine will start to stutter, like it wants to die. I pull back on the throttle and wait a minute and she will then run fine. Last year I...
  2. X

    Milky gear oil...

    I did SB#56 to my 2006 BF 225 almost 3 yrs ago. Here are some pics................................... I tried every which way couldn't get pics to come straight up.
  3. X

    Salt Away

    Does anyone have any experience or opinions about using this product on their engine to help minimize salt corrosion?
  4. X

    water Leak 2006 Honda BF 225

    Well after replacing the VST and the motor running really well, today I ran the motor with garden hose to just check everything was fine before going fishing tomorrow, I discovered a major water leak coming from behind the fuel rails. It appears to be a hole in either the cylinder head or the...
  5. X

    Honda 2006 RPM problem

    My boat is a 2006 Pro line 25 WA, so the fuel lines are 13 yrs old, will make the change of them my next project. I do have a water/fuel separator installed and drain it occasionally during the season and install new filter once a year. There is a small craft warning out today, so will make sea...
  6. X

    Honda 2006 RPM problem

    Hi Guys, I am in need of your assistance. The other day while running my motor on the water, it started to drop RPMs and then jump back up, then drop down and up again the entire time. I could reach high RPMs, but it stil would drop down and back up again. At idle it did sound like it had a...
  7. X

    Fuel line connector

    Hi everyone, I am in need of your help again. I couldn't free up the screw on the VST to drain it on my 2006 bf 225 hp. I tried drilling it out but that didn't work, so I am just going to change the pump case. While disconnecting all the hoses on the VST, I broke the fuel line connector on the...
  8. X

    Engine Gateway

    I have been wanting to receive more data from my 2006 BF 225 engine to display on my Simrad GO9 MFD. Seen some info about a device made by Fox Marine located here in MD. They make a engine gateway for older engine that are not compatible with NMEA 2000. Has anyone purchased and installed this...
  9. X

    VST drain screw

    I went to drain the VST on my 2006 BF225 and the drain screw is frozen. On some other post I read that it can be removed with a drill bit and an EZ out. Anyone have info on what sizes to use and possible pics or instructions to how to do this. Thanks in advance.
  10. X

    2006 BF 225 hp oil leak found

    CHawk, took your advice and started a thread about the internal anodes. Finished putting outboard back together, ran it a few times with muffs on and so far looking good. hoping to get out tomorrow to do a run and catch some rockfish.
  11. X

    2006 Honda BF 225 Internal Anodes

    While doing some engine repair on my 2006 Honda BF 225, I decided to remove the exhaust manifolds and found my internal engine anodes to be in very bad shape. I purchased new anodes and new screws from Boats.net and replaced the worn anodes. Here are pics of the parts numbers. Here is a...
  12. X

    2006 BF 225 hp oil leak found

    I am so glad that I decided to remove the exhaust manifolds. When I did I discovered that the internal anodes were in very poor condition and will be replaced.
  13. X

    2006 BF 225 hp oil leak found

    Well it seems like Photoshop wants people to pay for usage now and that is why my pics in previous post have disappeared. So here are the pics.
  14. X

    2006 BF 225 hp oil leak found

    I bought the boat and motor used last December. I did the SB #56 already. Last week I had an oil leak down the starboard side of the engine. Today i pulled the power head and found that the cover actually had a piece missing from the side. It turns out it was coming from the mount rubber...
See more
Back
Top