Back again, with my 1980ish Mariner 55 2 cylinder (Yamaha).
I have been told a couple of times from different sources that my crankshaft seals need replacing. Is there anything to be gained from a leak down test? I have no reason to doubt what I am told, this is an old outboard that gives me...
Today I took my boat to the main public boat ramp nearby to test if it would run or even idle, should have stayed in bed. The outboard is a 1975-78 Mariner 55hp (Japanese built Yamaha copy 2 cyl 2 carbs).
On the trailer the outboard fired up and idled like a champion. After letting it warm up I...
Where do I connect a tachometer to a 2 cylinder Mariner 55hp (Japanese built). The manual says to the two green wires from the stator. One goes to the termination block, the other has a connector mid way to the rectifier. Can I just disconnect the rectifier here and hook in the tacho? Should I...
Following the general instructions on youtube I knocked together a home made carb synch gauge (manometer perhaps - two plastic bottles with two stroke oil to less than half full, connected by plastic tubing and fitted with two vacuum lines that connect to carb vacuum ports). Are these ok to use...
I have a 2 cylinder Mariner 55hp (Japanese Mariner) and I'm concerned about the fuel line I installed since rebuilding the carbs. I have a 3/8" (10mm) fuel hose from the tank through the primer bulb to the outboard connector, then I have 3/16" (4.6mm) hose from the connector through the...
I'm sure others will know where to start diagnosing this problem, you guys seem to know it all collectively.
In the driveway with the hose attached my outboard runs and idles just nice, put it in proper water and it refuses to start and if you get it to start it refuses to idle. I've resorted...
The answers to my questions on this forum have helped me to rectify a number of problems with my 1978 Mariner 55hp 2 cylinder outboard (Yamaha built), I am thankful to you all for your advice and knowledge.
I've now had this outboard for over 12 months so I'm getting to know it fairly well. It...
Is there a reason to use a battery isolation switch on small craft where only one battery is used for all purposes? Is there a need to have an isolator?
So far I haven't been on the water over night so running my start battery flat while out isn't a problem (I have upgraded all my old...
Would it be safe to attach a mains power battery charger to a battery installed on a boat while it is still wired in but isolated from the outboard motor by use of an open switch? I don't intend to permanently wire in the charging unit, just trying to make it more convenient than removing the...
I am currently pushing my old late '70s 15'/4.5m fibreglass half cabin boat with the original 55hp 2 cylinder 1978 Mariner it was fitted with from new (only got this outfit last year). I am considering re-powering to a more modern outboard but am unsure which way to go. We (3 kids, wife, and I -...
Today my outboard started nicely and ran flawlessly all afternoon. However, on subsequent starting a few times, on first hit of the key it would only turn over very slowly. Not wanting to drain the battery too much I would stop cranking the motor before giving it another try. On the second of...
Today I ran my outboard in the driveway with the hose attached and found that there were some blobs of black goo, oil like but definately not new looking. This stuff was being thrown out from the exhaust a short distance while the outboard was running, some of it washed off the concrete and...
My 1978 Mariner 55 (2 cyl Yamaha version) hates the water at our local boat ramp. It will start effortlessly in the driveway, runs beautifully on the water, but hates starting/idling when the boat is sitting in water (not just at the one boat ramp). Last year I stripped and cleaned the carbs...
This post is more of an awareness raiser than an issue that needs solving. For some time I have been having intermittent problems with my starter motor which I assumed, due to age, was caused by poor wiring connections or worn brushes inside the starter motor base. The motor sometimes works...