Hi Pros,
Thank you in advance for your help. Here is the situation.
Motor: 2013 Honda BF50D EFI
Problem: I see a sheen on the water when I use my tilt/trim and eventually it runs low on fluid and needs to be refilled or it doesn't move - especially in the up direction. I've filled it 2 times now...
Anyone have the pages from the service manual to replace the trim/tilt seals for a BF50D (it's a 2013 if that matters).
Any tips would be appreciated too. All I know is it has a leak somewhere. It's been making that squealing noise and sometimes not coming up. Also, when I went to refill it...
Hey folks,
I need a little help troubleshooting this issue.
I have a 2013 fuel injected 50hp on my tender
it surges non stop almost like losing a cylinder but it’s very consistent. I lose between 200-400 rps each surge about every 10 seconds.
Here’s what I’ve trued
1. pumped the ball while...
Boat:
Silverton 330 Sport Bridge
2002 Crusader 5.7L MPIs
Raw water cooled.
Both engines running off the same tank.
Motor in question just had heads replaced and timing done with new plugs.
Filtration from Tank to Motor.
1 Hocky puck filter
1 paper filter on high pressure fuel pump in the FCC...
First I'd like to say that the motor is running really well. Like super well but it shakes a lot at idle. Just took it from Newport to Catalina this weekend on a 12 foot center console dinghy. It was an amazing trip. My issue is the engine shakes a lot at idle. Almost seems really rough.
This...
Mike,
Not yet. I actually found a good deal on that 06383-ZV5-315 Resistor Assembly so I was going to try that first. It just arrived this morning. I'm going to try to figure out how to install it and get it to work. I really hopes this solves the problem.
Here are pictures of the resistor and...
So I have a 3Cyl 4 Stroke honda BF50 (2004) on a 12 foot center console rib.
The engine is supposed to idle around >1k and redline somewhere around 6k rpm.
My tach won't go past 3000 RPM. I understand there may be a rev limiter at neutral but even out on the water at WOT it stops at 3000.
I've...
Good morning everyone,
I'd love some help in diagnosing my issue, I've done a lot of homework so you experts should have an answer for me ;)
Engine: 2002 Crusader 5.7 MPI motors. Raw water cooled. About 400 hours on it.
Issue symptoms: There is definitely water in the oil and there is a valve...