Logo
FULL SITE MENU

Search results

  1. V

    Trim Tilt Water Intrusion and Leaking Fluid - Please help

    update: it’s not leaking from the seal at the ram. It’s leaking from where the reservoir tank and the main assembly body meet. What do y’all think
  2. V

    Trim Tilt Water Intrusion and Leaking Fluid - Please help

    Hi Pros, Thank you in advance for your help. Here is the situation. Motor: 2013 Honda BF50D EFI Problem: I see a sheen on the water when I use my tilt/trim and eventually it runs low on fluid and needs to be refilled or it doesn't move - especially in the up direction. I've filled it 2 times now...
  3. V

    BF50D Trim Tilt seals replacement service manual pages please

    Anyone have the pages from the service manual to replace the trim/tilt seals for a BF50D (it's a 2013 if that matters). Any tips would be appreciated too. All I know is it has a leak somewhere. It's been making that squealing noise and sometimes not coming up. Also, when I went to refill it...
  4. V

    Honda BF50D (fuel injected) rpm fluctuation stuttering surging need a pro

    Hey folks, I need a little help troubleshooting this issue. I have a 2013 fuel injected 50hp on my tender it surges non stop almost like losing a cylinder but it’s very consistent. I lose between 200-400 rps each surge about every 10 seconds. Here’s what I’ve trued 1. pumped the ball while...
  5. V

    Crusader 5.7 MPI RPM Loss Mystery Please help me find this issue... Lot's of steps taken already

    Boat: Silverton 330 Sport Bridge 2002 Crusader 5.7L MPIs Raw water cooled. Both engines running off the same tank. Motor in question just had heads replaced and timing done with new plugs. Filtration from Tank to Motor. 1 Hocky puck filter 1 paper filter on high pressure fuel pump in the FCC...
  6. V

    Honda 2004 BF50 Nasty Shake at Idle - Who can help. I've tried everything...Well almost

    First I'd like to say that the motor is running really well. Like super well but it shakes a lot at idle. Just took it from Newport to Catalina this weekend on a 12 foot center console dinghy. It was an amazing trip. My issue is the engine shakes a lot at idle. Almost seems really rough. This...
  7. V

    Honda BF50 Tach Help...Solve this mystery...

    Mike, Not yet. I actually found a good deal on that 06383-ZV5-315 Resistor Assembly so I was going to try that first. It just arrived this morning. I'm going to try to figure out how to install it and get it to work. I really hopes this solves the problem. Here are pictures of the resistor and...
  8. V

    Honda BF50 Tach Help...Solve this mystery...

    So I have a 3Cyl 4 Stroke honda BF50 (2004) on a 12 foot center console rib. The engine is supposed to idle around >1k and redline somewhere around 6k rpm. My tach won't go past 3000 RPM. I understand there may be a rev limiter at neutral but even out on the water at WOT it stops at 3000. I've...
  9. V

    Need advice and problem identification...Have done a lot of troubleshooting - Water in Oil

    Good morning everyone, I'd love some help in diagnosing my issue, I've done a lot of homework so you experts should have an answer for me ;) Engine: 2002 Crusader 5.7 MPI motors. Raw water cooled. About 400 hours on it. Issue symptoms: There is definitely water in the oil and there is a valve...
Back
Top