Logo
FULL SITE MENU

Recent content by unclebob

  1. U

    Opinions on Etec 150 HP

    Looking at a used 2012 Hurricane 201 deck boat with same year Evinrude 150 HP (not HO model). I have not inspected boat myself but both boat & motor are pristine in pictures of ad. Owner claims extremely low hours, (69 hrs) and boat has always been stored sheltered on trailer. I know the Etec...
  2. U

    Advice on Evinrude outboard

    Seeking opinions on a 2010 model Evinrude Etec 60 HP 2 stroke engine. Owner claims 75 hours but I would like to know what engine compression values should be in terms of PSI. I know that each cylinder should be close to each other. Also, does anyone know of any track record with this make/model...
  3. U

    Seeking opinions on Yamaho outboard

    I looking for any opinions on a Yamaha outboard OX66 saltwater series 200 HP . It is a 2004 mode with 325 hours. I have never owned a Yamaha outboard so I am trying to determine if it this model has a good or bad reputation with other owners or mechanics. It is on a 2004 Wellcraft Tournament...
  4. U

    Oil mix protection in Merc outboard

    I have a '94 Merc 60 hp outboard with auto oil injection. When I trailer the boat, I just shut off the engine and leave the fuel hose connected to the engine. I was wondering if you disconnected the fuel and let the engine run dry, will the oil mix with the gas when you primed the carbs again on...
  5. U

    What brand of trolling motor to purchase?

    I have a need to replace my old Motor Guide bow mounted trolling motor, ('94 model, no parts available). I have been researching all the brands that are available on the Internet, (Minn-Kota, Motor Guide, Haswing, & Watersnake). I have also read a lot of user reviews on all these products and...
  6. U

    Excessive smoking at idle.

    '94 Mercury 60 HP tracker, 2 cycle on 17 ft aluminum boat. Last few outings, I noticed that engine smoked noticeably more than in past at idle. I checked the idle screws setting, (1.5 turns out). I thought maybe the one of the carb floats may be stuck but I'm not sure. This happens when motor is...
  7. U

    Need advice on purchasing an inductive tachometer

    I am going to purchase an inductive tachometer for use on my 3 cyl., 60 hp Mercury outboard. There does not seem to be a big selection of these available and some of the customer reviews are not good. I would like feedback on what some of seasoned mechanics use or recommend. If it is not...
  8. U

    Instructions for using a DVA adapter?

    I need to purchase a DVA adapter to troubleshoot my 60HP Merc. I have the factory manual for this model and read the CDI manual that outlines the importance of identifying the true voltage characteristics of the electrical circuit. I have also read that you must need to know how to use one...
  9. U

    Faulty tachometer?

    I have a 1994 Mercury, 60 hp, 2 stroke outboard that has developed a problem with erroneous tachometer readings. This problem has surfaced before recently and then went back to normal readings without any adjustments. Last couple of times out the tach reads about 300 rpms too high at idle...
  10. U

    Question about low oil sensor?

    I recently diagnosed a problem with a continuous sounding alarm horn on my 60 hp Merc, ('94 model). The sensor was defective and I replaced using suggestlons from previous posts. This fixed the original problem but when I was troubleshooting the original problem, I discovered the probe sensor...
  11. U

    False overheating alarm

    I have a '94 Mercury 60 hp outboard. Took it to the lake yesterday and a couple of minutes after starting, (still on trailer) the alarm goes off. I immediately stop engine and check motor temp by placing hand on head. It is cool. so I check thermostat which is O.K. The pee tube is working fine...
  12. U

    Rough Midrange performance

    I have a 60 HP Mercury, 1994 model with low hours. I purchased it about 2 yrs. ago and the overall performance is good. However, it has a rough spot between idle and 2000 rpm. It seems like an engine miss but the spark is good on all cylinders thru this range, (checked with an adjustable spark...
See more
Back
Top