I currently have a TP 14 1/4 X 17 Stainless Steel prop. The hub seems to have separated from the prop? I am not sure if this needs a new hub or what is going on. I've had it off but cant remember what it looked like. The hub itself seems fine and it doesn't look like it was pressed in.
Can...
1998 150 TLRW. When checking the sensor, should the resistance change over the range for both black to pink AND black to orange?
Im measuring black to pink = 807 to 10 ohm. This reading changes I when I move sensor
black to orange = 1046 ohm. This reading does NOT change as I move the...
Model number on plate is 150TLRW. Second line is 6G4 L 351868 V
How do I know which of these TLRW are my motor???
Model 150TJRW
Model 150TLRW
Model C150TLRW
Model C150TXRW
Model D150TLRW
Model L150TXRW
Model P150TLRW
Model S150TLRW
Model S150TXRW
Installing new to me motor. This particular motor is directly hosed to the filter. Is this typical? It doesn't have a connector (fuel pipe joint).
Can someone please recommend the proper fuel line (to purchase by the foot) for this motor.
1979 Evinrude 140. I have to hold the throttle control at planing rpm. If I don't hold the throttle the rpms will slowly decrease. Which way do I need to adjust the throttle cable? Loosen or tighten?
Thanks.
I have a persistent lean condition at idle and it wont stay running shifting from N to fwd or rev. I believe I have done everything (over and over) such as clean carbs check link/synch. Compression is goo etc.
I have seen Joe Reeves post about changing the jets. Can anyone advise? Do I go...
18 ft aluminum starcraft. usi
18 ft aluminum starcraft. using 2 pieces of 3/4 in treated plywood. I plan to bond these together with 3M 5200. Any comments before I do this? Thanks
I wonder where someone gets a
I wonder where someone gets a "REAL" manual. Original Service Manual...Not the seloc versions. Need a service manual for a merc 850 1979.
"Having a heck of a time with
"Having a heck of a time with installation. WHAT IS THE TRICK????? springs compressed into the valve body, thermostats in place and then having enough room to place the thermostat cover between the exhaust cover and the rear motor cover. Do you have to remove...