Logo
FULL SITE MENU

Search results

  1. S

    Prop question for 150TLRW

    I currently have a TP 14 1/4 X 17 Stainless Steel prop. The hub seems to have separated from the prop? I am not sure if this needs a new hub or what is going on. I've had it off but cant remember what it looked like. The hub itself seems fine and it doesn't look like it was pressed in. Can...
  2. S

    Trim position sensor testing

    1998 150 TLRW. When checking the sensor, should the resistance change over the range for both black to pink AND black to orange? Im measuring black to pink = 807 to 10 ohm. This reading changes I when I move sensor black to orange = 1046 ohm. This reading does NOT change as I move the...
  3. S

    Bulkhead Reducing union fuel fitting

    I need a 3/8 to 5/16 bulkhead brass reducer. Anyone know where I can get this?
  4. S

    How do I know the first letter of my model number???

    Model number on plate is 150TLRW. Second line is 6G4 L 351868 V How do I know which of these TLRW are my motor??? Model 150TJRW Model 150TLRW Model C150TLRW Model C150TXRW Model D150TLRW Model L150TXRW Model P150TLRW Model S150TLRW Model S150TXRW
  5. S

    Yamaha 150TLRW Fuel Line

    Installing new to me motor. This particular motor is directly hosed to the filter. Is this typical? It doesn't have a connector (fuel pipe joint). Can someone please recommend the proper fuel line (to purchase by the foot) for this motor.
  6. S

    Evinrude 140 Throttle Cable - QUICK QUESTION

    1979 Evinrude 140. I have to hold the throttle control at planing rpm. If I don't hold the throttle the rpms will slowly decrease. Which way do I need to adjust the throttle cable? Loosen or tighten? Thanks.
  7. S

    Joe Reeves Re Jetting? 1979 Evinrude 140

    I have a persistent lean condition at idle and it wont stay running shifting from N to fwd or rev. I believe I have done everything (over and over) such as clean carbs check link/synch. Compression is goo etc. I have seen Joe Reeves post about changing the jets. Can anyone advise? Do I go...
  8. S

    1979 Merc 850 TiltT Bleeding

    Replacing hoses and dont have Replacing hoses and dont have diagram or manual. Most sae30 leaked out. Where do I refill and how do I bleed? Thansk!
  9. S

    Transom Material

    18 ft aluminum starcraft. usi 18 ft aluminum starcraft. using 2 pieces of 3/4 in treated plywood. I plan to bond these together with 3M 5200. Any comments before I do this? Thanks
  10. S

    Repair Manual

    I wonder where someone gets a I wonder where someone gets a "REAL" manual. Original Service Manual...Not the seloc versions. Need a service manual for a merc 850 1979.
  11. S

    1982 Johnson 50 Horse Part Needed

    "Looking for a SKU: SKU: 03856 "Looking for a SKU: SKU: 0385656, STOP LINK, Port. This little part seems to be discontinued. #48 in this pic 48
  12. S

    1979 Evinrude 140 Thermostat Replacement

    "Having a heck of a time with "Having a heck of a time with installation. WHAT IS THE TRICK????? springs compressed into the valve body, thermostats in place and then having enough room to place the thermostat cover between the exhaust cover and the rear motor cover. Do you have to remove...
Back
Top