My manual says to use 30 or 40w engine oil but that was written in 1985. I’ve been using 30w in it but want to know if there is anything better or is 30w still preferred? I replaced the original outdrive 3 or 4 years ago with a rebuilt one so want to do what’s best. Thanks for any help.
Robert
I have a 1996 200 EFI. The stated rpm range is 5000 to 5800. The prop I have on it now gets me to 5800. Is it better to prop closer to the middle range or even the low range or is it OK to keep things as is? What’s the advantage of going up in pitch to drop rpm’s?
I have a new 383mpi and live in Santa Barbara where it never gets below freezing. I don’t use the boat much from November till about February or March. What should I do to maintain it? Should I start it every so often? It’s on a trailer in my driveway.
Robert
I posted a question about issues with my 1996 200hp efi. What would the symptoms be of a bad ECU and or fuel pump? I replaced the manual one and it didn’t change anything.
Robert
I started having issues where the engine would lose power for a second or so while running down the lake. Sometimes it would run very rough trying to get up to speed but finally “catch” and run ok. I replaced the non electric fuel pump last week but that didn’t help. Today it ran ok for the...
The new engine only has about 15hrs on it. I can’t tell where the rattling noise is coming from but it goes away when in gear. Is this something to be worried about or anything I need to do?
Robert
New repower with around 15hrs. Noticed this rattling noise at idle. It goes away when in gear (last half of the vid). I don’t remember hearing this before but could have missed it. Is this anything to worry about, or something I need to do about it?
Robert
Edit. It’s paired with a Volvo Penta...
I just Repowered with a new 383 mpi and have it networked to my Simrad MFD with a vessel view link. On the Mercury screen there is troll control and cruise control functions. I’m trying to find out if this engine is compatible with these functions. Does anyone know if the 383 is compatible with...
I can start it by squirting gas in a cylinder or two and keep it running for a bit by using the push in key for choke modification I did years ago to help with cold starts but it now won’t stay running without having the key pushed in and eventually it will stall. I tried giving it some throttle...