I am looking at an E140cxccs that has no spark. The powerpack has been replaced and I unplugged the wiring harness to bypass the switch. I am thinking I should check the stator and timer base. I have a meter but don't know what kind of readings I should get. Thanks for any help or ideas.
I am cleaning the carbs on a m
I am cleaning the carbs on a mariner 50 hp. The serial # is OD132973 but that don't match up to the WM-15 carbs on it. It is a 3 cylinder with 2 carbs and I am looking for a rebuild kit. Thanks in advance for any help.
I recently rebuilt a 96 70hp f
I recently rebuilt a 96 70hp for my cousin. It now has good compression and idles great. He said when he took it to the lake it ran good for a little while but then would stall in gear. He had a mechanic look at it and told him the plugs were fouling really...
"this engine had been sitting
"this engine had been sitting for a few years until I decided to fix the boat up. I hooked everything up and it fired right up. let it sit a couple days and it fired up again. today I went out and no fire, I disconnected the black/yellow wire and no change. Just...
ready to put this engine back
ready to put this engine back together and was wondering if anyone can tell me the torque specs for the rod bolts. I assume the head bolts are 18-22 ft lbs and was thinking maybe 24-26 for the rod bolts but I know what happens when we assume so I thought I would...
"A friend of mine has a 1977 e
"A friend of mine has a 1977 evinrude 200 and the lower unit is stuck in forward gear. I have never worked on a lower unit before other than simple water pump replacement. He might buy a used replacement anyway so I thought I would give it a try. I am just...
I am rebuilding a 1996 E70TLED
I am rebuilding a 1996 E70TLEDA for my cousin and the pistons that came out of it are stamped 435547 which doesn't match up to the numbers on the ones for that engine. I am wondering if they are the same size or if the engine has been bored any? I just do this on...
I am rebuilding my first outbo
I am rebuilding my first outboard for a friend. It is a 1988 3 cylinder 60hp evinrude bored .030. I know we should buy the book but he is on a tight budget. I am wondering if anyone can help me with the torque specs. I think I need them for piston rods and head...
wondering if anyone can tell m
wondering if anyone can tell me what year evinrude this is. Model # E60TLCCR
SER # G1794391
Think it is early to mid 80's
"I am looking for a used flywh
"I am looking for a used flywheel for a 2000 ficht 225. The numbers on it are 586506, any help in the right direction is appreciated."
can someone tell me if the ign
can someone tell me if the ignition coil on a 225 is the same as the one for the honda minivan. It looks the same but I don't know if it will work.
my 2003 225 ran perfect at idl
my 2003 225 ran perfect at idle to 2000 rpm's but then when i gave it more throttle it struggled to stay alive. When I backed off it cleared right up. I changed the fuel/water separator which had water in it but still no help. Then I changed the VST filter but...