That is the one with the red switch on it right? I have to manually turn that from closed to open and back for the engine to function normally and not stall
I have an 86 Johnson 60hp outboard and have done the vro conversion to get rid of the oil pump. It ran fine for awhile and I cleaned the carbs and did the adjustments the book says to do to put the motor and controls within spec. I have discovered that if I start the engine and try to...
So we were removing the flywheel and it broke. Now I'm catching hell trying to find a new flywheel. S/N 30035 on the motor. Stamped number on the flywheel is fwm2016. Can't find it anywhere.
So I did the fuel pump conversion and now it runs. Put in the water today and every time I either tried going forward or back the engine just died out. In the yard I could throttle it all the way out with no problem. But under load the engine bogs out and dies. No change in how quickly it dies...
Leaking from the center seam in the middle of the pump. Don't know if I can just replace the seal inside or the whole pump.
This is the pump that's in it. Not sure if it attached from my phone.
Just got this boat from my wife's grandma and when I went to put fuel to it and primed the line it started squirting fluid out of the seam of the pump. Looks like the conversion was done