I have a 2013 3.0 MPI running on the vessel view and recently had to replace a TPS sensor and a 02 sensor will these warnings go away on their own over time or is their a reset procedure?
I have twin 2008 bf 200’s and recently my port motor takes minutes to idle down to 650 rpm where it eventually settles. It lingers at 730 rpm for long enough that I can’t shift it and end up shutting it down to dock. I have no codes and I have cleaned the IAC and checked for intake leaks...
27249
Just a couple screen shots for your viewing pleasurer at this time both of my 2008 bf200's are running well with no alarms. the signal voltage from the o2 sensors bounces around a lot. And the hours reported from the healtech are 100 hrs less than indicated on my gauges not sure what that...
Soooo why are the exhaust valves on separate rockers and the intake valves on a common single rocker, inquiring minds want to know...... specifically my 2008 BF 200’s
I have twin 2008 bf 200s and was trying to find the part number for the little rubber grommets that fit into the cowl cutouts to help prevent the paint chipping around the ports. The motors did not come with them in 2008 but were added in later years. I found this but dont know if it will fit...
So i have twin 2008 BF200's that will be laid up for at least 5-6 months in the effort of not doing any more damage to our already delicate O2 sensors whats the majority say?
1 Fogg-em good through the intake don't worry O2's are cheap:eek: 355 hrs already replace both:(
2 Pull plugs and...
One of my BF200’s is in need of a new 02 so I bought a OEM unit for $200 I would like to know if anyone has had success cleaning and reinstalling the original unit? Thanks
My closing statement unless my next sea trial is bad is that it is fixed and the issue was human error. My barrel was not deep enough to cover the primer hole in the pump housing an thus I’m a dumb ass. My original problem was crud forming a blockage in my cooling system. I solved that problem...
Back flushed again today and got a bunch more stuff out of the motor. With the leg off and the garden hose attached directly to the pick up tube I get no air bubbles at all a steady stream coming from the pisser. I left the volume low enough to replicate the other motors stream at idle. It does...