Logo
FULL SITE MENU

Recent content by kjdavi76

  1. K

    Evinrude 200hp Vindicator flywheel?

    Hey all I am in search for a good used flywheel for a 1996 Evinrude 200HP Vindicator flywheel. Model E200STLEDM. I bought a reman flywheel for $600 and the thing arrived bent and with broken magnets so had to send back and now I cant find another one. Part number is 0583427/0583427. Anybody out...
  2. K

    Rebuilt Motor Blowing gas out carbs

    1995 Evinrude 200 Vindicator E200STLEOA Rebuilt the engine and now it wont idle or run right. The carbs are blowing fuel out instead of sucking it in. Would installing the pistons with the exhaust side of pistons aligned with the intake side. Motor turns nice and free and has good compression...
  3. K

    Johnson 50hp no spark

    I have a Johnson 50hp model J50PLEEA. It has no fire from the CDI unit to the coil pack. I have put 2 brand new CDI boxes on and 2 new timer bases still nothing. I have installed a new keyswitch and traced every wire out on the motor. It has a new stator, coil pack, plugs and wires, CDI box...
  4. K

    1975 evinrude 85hp rebuild issue

    I am rebuilding a 1975 85hp Evinrude model 85593-E. I sent the block off and had the cylinders bored .020. The company that did the block sent new pistons and bearings for the crankcase along with new rod bearings and bolts. So I have intstalled the pistons and connected them to the crankcase...
  5. K

    2011 Mercruiser 3.0 MPI

    I have a 2011 stingray runabout with a 2011 mercruiser model MCM 3.0 MPI. The pink wire on the Fusibles test link is blowing the 20A fuse as soon as the ignition switch is turned on. I have found that wire is going to ground with a multimeter. I have traced the wire all the way through the...
  6. K

    Starter turning backwards

    Hey everyone. I have a problem with my starter turning the flywheel the wrong direction and when the motor tries to start it kicks back the other direction and is breaking the teeth on the starter. I can see the flywheel cjange directions when it does start every once in a while. Ive never seen...
  7. K

    2004 Yamaha 40 TLRNC timing issues

    I have a 2004 Yamaha 40TLRNC. It wont go over 2500 rpms on the water or over 4000rpms on muffs. I have changed the fuel pump, rebuilt carbs, chabged thermo switches, replaced charge coil. I checked timing with a timing light and it is showing 28 degrees btdc and from what i gather it should be...
  8. K

    50hp evinrude have to use choke to get WOT

    I have a 1983 evinrude 50hp model E50BELCTA. I have replaced everything electrical on the engine except the primer solenoid and have taken it apart and it seems to be working properly. All fuel lines have been replaced. Timing has been checked on the lake. Everything is good the motor runs good...
See more
Back
Top