Current visitors

Home
Members

kevinj's latest activity

K

kevinj replied to the thread Plugs and gas.

Always Champions plugs in my Evinrude engines and Faztbullet gave you the right plug # for your engine. I also exclusively run...

Mar 27, 2024
K

kevinj replied to the thread Grease for assembling new pistons on to old rods/needle bearings...

Oh boy, now you're going down a rabbit hole! You can sometimes find a real gem and you can also find a pile of scrap. There are plenty...

Mar 25, 2024
K

kevinj replied to the thread 1996 Evinrude keeps shutting off.

You have a fuel delivery problem. This could be an air leak in the lines, a sticking anti-siphon valve in the tank, a bad diaphragm in...

Mar 21, 2024
K

kevinj replied to the thread 95 johnson 115hp fast strike no spark.

The CDI Electronics installation and troubleshooting guide will help you know the exact readings you should have on each lead.

Mar 15, 2024
K

kevinj replied to the thread Idle and timing adjustment 1992 Evinrude 88 hp.

Is that 1500RPM out of the water on muffs or in the water? Without any back pressure, 1500RPM on a set of hose muffs isn't too far out...

Mar 15, 2024
K

kevinj replied to the thread 1996 200hp johnson evenrude outboard motor.

I believe faztbullet's question is which BRAND of aftermarket power pack did you buy? If it's Sierra or CDI electronics they tend to...

Mar 15, 2024
K

kevinj replied to the thread Lower end oil??.

Yep, BRP HPF Pro is what I use in my lower unit. A lot of people use Quicksilver because that's what is readily available at Walmart...

Mar 13, 2024
K

kevinj replied to the thread Shift rod replacement.

#1, make sure your shift shaft seals on the LU are in good shape, if not they will leak water in the LU. Now is the time to perform...

Mar 12, 2024
K

kevinj replied to the thread 225 Johnson won’t go into gear.

Agreed with Racer, we need a little more back story. As for troubleshooting, remove the shift cable from the shift linkage on the...

Mar 12, 2024
K

kevinj replied to the thread Want to turn my 78 35 horse Johnson back into a tiller.

Tims Outboard in MN has a great selection of good used parts for these older outboards. I had a 25HP short shaft I wanted to convert to...

Mar 12, 2024
K

kevinj replied to the thread Opinions needed Crossflow vs Loop Charged.

Fuel starvation at WOT will not present itself as a misfire. If you are fuel starved you'll either bog down or not be able to reach max...

Mar 6, 2024

Show older items

Home
Members

Top