I have a 1995 mariner 200. i suspect that it originated off of a fish n ski.
The question is, did mercury outfit the fish n ski boats with a different gear?
The reason I ask is my old motor was nearly 8 to 10 mph faster at he same rpm's.
Just wondering.
thanks.:confused:
I have a question on the alarm module.
If I remove the module, will the overheat alarm still function?
I see there is a wire tied in.
I have the pump looped to itself, and the tanks removed.
All I have left is the electrical.
Any help would be appreciated.
Thanks.
I have a 1989 evinrude 200 xp that sneezes and dies at idle in gear. It runs
great at all other rpms, however i sometimes have to push the chock in to come out of the hole. Once its up, it runs great. Vro is being used as a fuel pump only, and I am premixing. I did plug the oil line, and have...
Temp sensor 1989 evineude. E200STLCEB. Is there a way to test the temp sensors. I know if you ground the wire from the power pack the horn goes off. But I want to test th sensors themselves.
I have a 1989 Evinrude XP200 that has a skip ,or backfire at idle. if I run it W.O.T. for a bit, it will idle fine for a while, but will go back to the skip.
I have a new power pack, and I am mixing 50:1 with oil side of the VRO disconnected and plugged. what could cause this skip? like I said...
Im new to the site. I recently purchased a used Evinrude 200 xp. It was not running when I purchased it. It does have good compression, and after a new power pack, it's alive. However, there are a few issues i need help with.
Cooling.
I did replace the water pump. and checked the t-stats. they...