Logo
FULL SITE MENU

Recent content by Happyprinter

  1. H

    Need prop advice

    Good afternoon everyone. I have a 2005 Robalo with a Honda bf225 outboard. I am currently running a 3x15 5/8 x 11 prop. It will come out of the hole pretty decent til it hits 4000 rpm and then struggles to get to 4400-4500 where the vtec kicks in and then it goes great. I have tried several...
  2. H

    Boat Listing issue

    Have a Robalo R225 boat with a Honda 225 outboard. The issue I am having is that when I run on plain I have to use full trim to keep it from listing to the port side. Not just a little bit but a lot of lean to the port. At full trim, it still wants to lean to the port to the point that if...
  3. H

    Looking for Tech

    I have a 2005 Honda 225 and need a tech to go thru it for me. I am looking for a great tech in the Northern Utah area that can work on Hondas and knows their stuff! Past experiences with a local dealer has not been good. Any suggestions would be appreciated.
  4. H

    2005 225 not reaching full rpm

    Thanks to everyone for your past help. I have a 2005 225 Honda. When I initially start up after it has sat for say a week it puts out a small cloud of white smoke. And then no more smoke for the few days I am on the water with it and then when I store it for a Week and come back and start it...
  5. H

    Prop Question

    Have a question on prop size and what direction I should go. I have a 2005 Honda 225 on my Robalo walk around. Currently I have been using a Solas 15 5/8 x 11 prop. I am running at about 6500’ asl. It usually planes alright with just two of us in the boat with a full tank and gear. But when...
  6. H

    Honda 225 Power Curve question

    Curious if the power curve on my 2005 225 can be adjusted. Instead of kicking in around 4300-4500 rpm can it be made to kick in around 3800-4000 rpm? I have changed props several times and I currently have a 15 5/8 x 11 which does well til it hits about 4000 rpm then takes a few more seconds...
  7. H

    Lost power

    I have a 2005 Honda 225. Started fine this morning . Idled out of the harbor. when I went to speed up the engine died and now I have no power when I turn on the key to start. I still have power to my trim tabs when I turn on the key but not showing any voltage on my dash amp meter. Checked...
  8. H

    2005 Honda 226 Buzzer

    As you know from a previous post I have had issues with motor cutting out when I got to about 3500 rpm on start up out of the hole. It was suggested to change all the filters which I did but did not fix the issue. I started at the bulb and replaced it then the low side fuel pump, then the high...
  9. H

    First post, Honda 225 issue

    Good afternoon everyone. Just purchased a Robal walk around with a 2005 Bf225 outboard. Changed the high and low side filters. Drained the VST. When I throttle up, the boat will start to plane and them it acts like it is starved for fuel and sputters and loses RPM so I throttle back for a...
See more
Back
Top