http://www.ebay.com/itm/Chrysler-Marine-Exhaust-manifolds-318-340-360-NEW-PRIMED-PAINTED-/271113396652?hash=item3f1f9e21ac&item=271113396652&pt=Boat_Parts_Accessories_Gear&vxp=mtr
Grease
ALSO,Have some other FWC parts from a 318
Is # 7 some how easier to reach while setting up a timing light? Bingo was his Namo
Is there a specially marked or indexed harmonic balancer for this?......Is there special a timing marker made for chrysler MARINE engines that you cant explain??
Is there a special timing gear set that now...
Is this time for a rebuild or does the tranny sound like this!
http://www.youtube.com/user/captlazybone#p/u/0/rWi3HuAz7sw
Done some research in the install manual and seems a rough running engine,low idle causes this gear rattle and should go away with an elevated idle.The new mount I put on...
Starts every time, idles fine till its warm
then idles rough and stalls and hesitates when accelerated
Gas is goood ,Drained the VST ,cleaned out water seperator and in line fuel filter at engine
Found the inner lining of fuel hoses in the filter housing(clear rubber)
I assume the...
Got the new intake manifold gaskets there is no metal plates for the center hole
What do these plates do? And why does Napa and otherparts not have the plates
Anybody have a clue?
"What should I be doing while
"What should I be doing while I have this thing torn apart?Should I go ahead and take the intake off and inspect? What would yall do?Yep Im from the South!Check the valves?
Timing Chain?"
"Decided to dig in and let er
"Decided to dig in and let er rip,replacing the exhaust manny and mounts,clean it up a bit,looks like a tad bit off water in the #3 cyl. and 4 bolts came out easy but ole #7 got me just a bit right Jeff. Wonder if u guys got any suggestion as what I shoul do while...
Bout to haul it out and was wo
Bout to haul it out and was wondering if anyone had any ideas about adjustments or if they might have a pic of a trailer they use?
"Lookin for some help and sugg
"Lookin for some help and suggestions.I have a 318RH rotation starts and runs but not firing on all 8 to say the least.I have spark and new clean plugs and wires,seems that should cause the motor to run on 8.I wonder if the cam is worn and the valves arent...
So I get it warmed up and Im o
So I get it warmed up and Im only pullin 9 hgs of vac through the non pcv hose fitting and put it in gear and it'll spit and sputter and die .I pulled a total of 4 spark plug wires off and held them in my hand and engine ran at idle and plugs sparked on a tester...
"I have an issue on my starboa
"I have an issue on my starboard reverse rotation motor. I just put a new timing chain on because when I would try to start it , it would spit up through the carb(Carter reman).I could set the timing ,clean the plugs and it would run for 20 minutes and then start...