Throttle opens when shifted into reverse, but only when the handle's spring loaded button is held in.
Throttle opens when shifted into forward without having to touch the handle's button.
Is this normal, and is there a way to open throttle in reverse without having to press in the handle's...
Do both cables need to be channeled between the diamond shaped 1" x 2" piece, and the (apparent) barrel pocket holder attached behind it?
Is the diamond shaped alloy movable, so that I can run the cables through that finger-width gap?
This obstruction is 2" back from the cables' rubber seal, at...
40 mm thick timber is between the alloy transom and the Yamaha mount bracket which rests on a 65 mm wide x 300 mm long alloy surface centered in the transom's top, when the top two mount bolts are through the top two mount holes.
If I raise the Yamaha with the top two bolts in the 2nd, 3rd, or...
The helm also is labeled with '700010', and I loosened the t25 torx bolts, and the 10 mm hex bolts opposite them, but the cable inside still won't move an inch into the plastic excess tube. Steering to the motor's port stop limiter needs that extra inch.
Thanks for your help.
This 50 hp DETO model seemed to start spraying water out of its exhaust yesterday, and I can't remember seeing the exhaust spray on previous tests.
http://superfly.co.nz/Yamaha50/exhaust.jpg
Water flows from the telltale, as it did before.
What could have caused this change?
Thanks for your help.
The owner told me that the workshop left the plugs out, after its compression test(all between 138 and 140, he said) and that the engine has been stored with its plugs removed, under the cowl, for 9 or 10 months.
Would that expose the cylinders to dust and other contamination?
Thanks for your...
I was told this Mercury 650
http://superfly.co.nz/Mercury65/outer.jpg
had 3 cylinders and 'electric ignition'.
Its year isn't critical, but I'd like to know the ignition system under the hood.
Thanks for your help.
The page of Sierra ignition parts listed "-" under contact points for a 15 hp.
Are points and condenser still available for an engine that looks like
http://superfly.co.nz/Chrysler15/outer.jpg
http://superfly.co.nz/Chrysler15/exposed1.jpg
http://superfly.co.nz/Chrysler15/exposed2.jpg
The...
The .pdf manual I bought indicates that my engine has a Walbro WM carburetor, and the first steps in removal are
"1- Using a pair of pliers, remove the Circlip
securing the choke knob in place.
2. Remove the choke knob by pulling it straight out.
Unsnap the idle wire from the primer bracket...