Hello,
Hoping someone can help.
I have a Mariner 1997 40hp 2stroke 2cyl electric start made in Belgium.
The magnets on the flywheel disintegrated, however it kept running fine.
I removed the flywheel and tried to source a new part. The flywheel on the outboard has the part number 261-9007-C3...
Hi. I have a 1992 Mariner 6E9 40hp. Does anyone have any experience of converting one to electric start? If so, were there any issues you came across?
Thanks
Hi,
My 6E9 seems to misfire or run on one cylinder whilst idling. It clears immediately when i give it some throttle and is fine at higher revs. Sometimes it will cut out as i shift it into gear, but mostly it's ok. Just thought I'd ask before going to inspect it.
Thanks
Wondering if anyone can help. I have a 2 stroke 9.9hp mariner 1989 I believe, engine number is :9540489
I need a general carb service kit, however there are 3 different ones listed. If anyone could point out which one I need ( possibly on brunswick marine) i would be most grateful.
thanks
S.Edwards
Hi all,
I recently removed the lower unit from my 1988 2 stroke 9,9hp Mariner (Belgium) in order to replace the seals as the oil was contaminated with water.
I noticed that the bearing on top of the lower unit was corroded and I was advised to inspect the propeller shaft bearings.
I was told...