This motor is still new to me, I have noticed it will shake pretty good at times at idle. It starts great and runs good but at idle can literally shake the boat.
Any thoughts or ideas
I have a Yamaha 40 hp 40TLR 6H4K L - looking to change impeller for the first time. I have the impeller purchased looking for any instructions or advice on procedure. I have searched and watched a view videos and talked to Marina. They suggested putting motor in forward gear before I drop the...
Purchased a used boat today with a 40 Hp Yamaha - 40TLR
Not sure the impeller has been changed since new which has me worried, I am sure this has been asked but how hard is it to change impeller on this model. Should I purchase service manual or are there downloads.
thanks for any info
What are some common fixes for idle issues, carb cleaner - sea foam etc ....
My little 6hp is no waning to idle- Evinrude E6RECR - trying to find a repair that I can do
I have a 98 Evinrude E6RECR that recently does not want to idle. I am going to change the plugs does anyone recommend brand and type of plug
I am also thinking about using some seafoam in the gas to clean carb
I will take any suggestions
thanks
I have a 1998 evinrude E6RECR that I would like to atempt chane the impeller, there is one single bolt that is easy to get to and then under the cavitation plate there are 3 small bolts that a socket or wrench will not fit. Does this take a special tool and do all three bolts need to come loose...
i want to extend my throtte on my 98 E6RECR Evinrude, possibly take pvc and split and use hose clamps. How would I find the diameter of the current hand throtte where I could place the PVC pipe. My motor is currently 45 minutes from my house.
If you have other ideas I will take them
thanks
My 98 6hp Evinrude was working fine until I tilted it up to come in to shore today, the throttle will not turn back to idle postion. I had marked Idle for me and my son so we knew where it was but know it will not return back so the idle is higher than normal and hard to shift
Any ideas what...
I have an older 6 hp Envinrude and would like to purchase new prop, I have no idea what the size or pitch. where is the best place to purchase and figure out size and pitch
1998 evinrude E6RECR - this is my motor
thanks
where could i find the user maunal for a 1998 evinrude E6RECR
and or maint manual also
thanks for help
note -it has 1997 by the serial number and on other side 1998
looking at a 2004 mercury tiller handle pull start 2 stroke short shaft - he is aksing $950
wondering if any issues with this motor and is this a good price
thanks for any replies and help
I have a 12' v bottom