You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser.
-
-
C
Figured out why the gap is larger for my spark advance linkage. Noticed today the roller on the carburetor valve opening mechanism was...
-
C
Wouldn’t that gap depend on how much slack there is in the throttle/gear cable? I checked and the roller contacts the spark advance arm...
-
C
Got her in the water and she runs great! Really impressed. After some research it sounds like the timing advance base needs...
-
C
She was finally started up today and purred like a kitten on muffs. We'll have to take her out to confirm everything is good.
Had a...
-
C
Not running the motor, turning the propeller by hand with the engine off. And the motor in forward gear without muffs.
-
C
And there is no way doing this without muffs on with water running could have damaged the impeller?
-
C
Just want to double check before I start it soon; I’ve been putting the boat in gear and spinning the prop by hand to move the pistons...
-
C
Back in November we got a new 5 gallon tank and I filled it up with 89 Ethanol free gas; filled to the top and mixed with XD-30 oil. It...
-
C
I've been going through the same thing this past winter ticking over everything on our 2004 Johnson 150 that sat for a few years. Looks...
-
C
Finished dropping down the torque to about 4 Nm or just under. Worked on one carb at a time so that I did not disturb the mating of the...
-
C
You are absolutely right, I should have paid more attention. I purposely didn't lube the screws for that reason but no telling if oil...
-
C
I'll split the difference. Since you've done 25 in-lbs (3 Nm) and the FSM says 5-6 Nm, I'll try 4 Nm and see if there is less bending...
-
C
And it’s the same style carb mounting system like in my photo where of the 4 carb mounting bolts, the top two secure the carb and...
-
C
Turns out the needles are fine. The lower two seated into a thicker wall that made it look as if they didn’t go in as far. I did some...
-
C
Right I know what they are for. The problem is they are seating in their respective holes at different depths. For example if I screw...
-
Loading…
-
Loading…