Logo
FULL SITE MENU

Recent content by brassfoil

  1. B

    Cd18 b61 55hp new impeller no water flow

    "Installed recommended 18-300 "Installed recommended 18-3001 impeller in my 5.5 hp but engine overheated from no water flow,even with thermostat out. Took waterpump and driveshaft out and turned it with a drill in a bucket of water;had volume of water about 2in. high at housing outlet...
  2. B

    Need part number in 1961 55 hp cd18

    Need part number for carbon wa Need part number for carbon washer located just under powerhead on the drive shaft.There is also a spring and metal cap on top of the spring.The carbon washer sits in top of the metal cap .
  3. B

    Need 1961 55hp part number

    Need part number for shaft wat Need part number for shaft water seal located below water impeller on a 5.5hp 1961 Johnson
  4. B

    Where engine diagrams before 1968

    I'm looking for a gasket f I'm looking for a gasket for a '61 5.5hp but can only find Engine diagrams going back to 1968.Would be nice to see exploded view of engine with part numbers
  5. B

    Carb throat dripping emulsion

    Started '77 85hp with star Started '77 85hp with starting fluid after 5 years in storage.While letting it idle I start to see grey thick liquid making a stream out the carb throats.Not alot but alarming because im thinking water in the block. Looks and feels like melted icecream.Is this a...
  6. B

    Need thermostat parts

    "I have 1977 85hp Johnson and "I have 1977 85hp Johnson and need the parts that make up the temp control.Part #47,53,54,55 on the omc schematic.I have the older model not the newer thermostat starting late'77 on.Any chance of finding new old stock?"
  7. B

    Oring size in Evinrude fuel connector

    Anyone know the part# or gener Anyone know the part# or generic size# of the Oring in an Evinrude fuel connector?I have a pile of them on my bench and tired of throwing down 5 bucks every time a replacable Oring gets nicked and leaks in air.
  8. B

    Need thermostat parts

    I have 1977 85hp Johnson and n I have 1977 85hp Johnson and need the six parts that make up the temp control.Only one part is still avaliable.Any scrap'73 to'77 should work.Anyone know of any sources?
  9. B

    Is there a separate low and high rpm circuit inside power pack

    "I have a 40hp 1990 that runs "I have a 40hp 1990 that runs great first 5 minutes in the water but after engine reaches correct temp it will only run perfect up to a certain speed and then with any more throttle it will cycle back and forth between trying to run faster and cutting...
  10. B

    Sand in cylintake port

    "What are my options? 1977 85 "What are my options? 1977 85hp Evin. Motor given to me.I was told engine overheats. Compression check shows 3 [email protected] 4 60psi.Take off cylinder heads and remove 7Tbl spoons of caked sand.Remove large exhaust plate -exhaust ash on plate at 3 areas but...
See more
Back
Top