Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
CORROSION PROTECTION
TRIM TAB
TRIM TAB
Fits Force Model 70B (1991), Force 70A (1992), Force 70C (1991‑1992), Force 70
Magnesium ‑ For freshwater use only. Do not use in Saltwater applications.
(0E000001‑0E138599), Force 75 (0E138600‑0E344999), Mercury/Mariner F40
Fits most Mercury/Mariner outboards 35 hp. & above and all MerCruiser except
FourStroke, 3 cylinder, Longshaft (CHN 1C000001‑1C049738), Mercury/Mariner
Bravo. Check for adequate propeller clearance prior to operation.
F40/50/60 FourStroke 996cc (standard gearcase 1.83:1 ratio) and also fits the
Mercury/Mariner 50hp. 2‑cycle, 3 cylinder, standard gearcase (USA
ANODE KIT
0D000750‑0G589999, BEL 9683055‑9973099), and 55/60hp. 2‑cycle, 3 cylinder,
standard gearcase (USA 0D000750 and above, BEL 9683055 and above).
TRIM TAB
Aluminum, located under the cavitation plate on the following products.
Force Standard Gearcase Models:
9.9/15 hp. 2‑cycle MY1998
Aluminum
Mercury/Mariner Standard Gearcase Models:
Fits most Mercury/Mariner outboards 35 hp. & above and all MerCruiser except
6/8/9.9 hp. 2‑cycle MY1986 & newer
Bravo. Check for adequate propeller clearance prior to operation.
F8/9.9 hp. FourStroke MY1995‑2004
F13.5 hp. FourStroke MY2001 & newer
Quicksilver Branded, Clamshell Package Point of Sale Packaged.
F15 hp. FourStroke MY1998‑2006
XR10
TRIM TAB
10 Marathon
10 Seapro
10 Viking
Quicksilver Branded, Clamshell Package Point of Sale Packaged.
ANODIC PLATE
EDP ‑ Black
Fits most Mercury/Mariner outboards 35 hp. & above and all MerCruiser except
Bravo. Check for adequate propeller clearance prior to operation.
Aluminum
Provides additional clearance for high rake propellers.
Fits Mercury/Mariner 35‑300hp, Force 90 & 120hp 1995 and newer, MerCruiser
Alpha One Gen II and Bravo I, II, III, X XR & XZ drives.
Priced individually, sold @ multiples of 2
Quicksilver Branded, Clamshell Package Point of Sale Packaged.
Magnesium ‑ For freshwater use only. Do not use in saltwater applications.
Fits Mercury/Mariner 35‑300 HP, Force 90 & 120 HP 1995 and newer, MerCruiser
Alpha One Generation II and Bravo I, II and III drives.
690