Quicksilver Marine Parts Catalog
- Contents
- Pre-1988 Mariner
- Mercury & Mariner
- Carburetor Kits
- Fuel Pump Repair Kits
- Ignition Keys
- Ignition Parts (2-Stroke)
- Ignition Parts (4-Stroke)
- Lower Unit Gearcase Seal
- Pistons
- Oil Filters
- Powerhead Gasket Sets
- Rod Main Bearings
- Solenoid Relay (2-Stroke)
- Solenoid Relay (4-Stroke)
- Spark Plugs (2-Stroke)
- Spark Plugs (4-Stroke)
- Stators
- Thermostat Kits
- Water Pump Parts (2-Stroke)
- Water Pump Parts (4-Stroke)
- Mercruiser
- Engine Parts
- View All »
- Alternators
- Camshafts, Bearings, Lifters & Push Rods
- Carburetors
- Connecting Rod Bearings
- Crankshaft Bearings
- Distributor Assembly & Components
- Distributor Gears
- ECMs, Coils, Wires & Spark Plugs
- Engine Couplers
- Engine Gaskets
- Exhaust Manifolds & Elbows
- Flame Arrestors
- Fuel Coolers
- Fuel Injection Components
- Fuel Pumps & Filters
- Ignition Tune-up Kits
- Intake & Exhaust Valves
- Oil Coolers
- Oil Pumps & Components
- Piston Rings
- Pistons
- Rocker Arms & Hardware
- Starter Parts
- Starters & Solenoids
- Thermostats, Housings & Covers
- Timing Chains & Gears
- Valve Caps, Springs & Keepers
- V-Belts & Serpentine Belts
- Water Hoses—Engine Supply
- Water Hoses—Exhaust Cooling
- View All »
- Transom & Drive Parts
- View All »
- Bearing Carriers
- Bellows
- Drive Shaft Housing & Sterndrive Units
- Drive Shaft Housing Bearings
- Drive Shaft Housing Gears
- Gear Case Bearings
- Gear Case Gears
- Gear Case Seals
- Gear Case Shafts
- Gear Case Shims
- Gimbal Bearings
- Installation Gaskets
- Trim Cylinders
- Trim Cylinder Hardware
- Trim Cylinder Hoses
- Universal Joints (U-Joints)
- Water Pump Impellers & Kits
- View All »
- Engine Parts
- Page Numbers
INSTRUMENTS
SPEEDOMETER PICKUP TUBING
MARINER - UNIQUE GAUGES
Gauges unique to Mariner outboards that will not be found in the
standard gauge families. Large gauge ‑ fits 3‑3/8 in.(86 mm) hole in
dash.
MODULE ASSEMBLY
53 ft.(16.15 m) tubing.
1 roll of 1500 ft.(457.5 m) tubing.
HOSE KIT
Tachometer Module Assembly. Adapts all Quicksilver tachometers, except
79-43984A 1, for use with Japanese built outboards.
SPEEDOMETER PICKUPS
SPEEDOMETER PICKUP
Contains the necessary tubing, tee fitting and instruction sheet to allow the use of a
15 PSI Analog Water Pressure Gauge with the otherwise digital 1.5L OptiMax
outboard.
Fits the 75/90/115hp (1.5L) OptiMax Outboard Engine, Model Year 2004 and
newer.
PITOT SENSOR KIT
Pickup and mounting screws only
SPEEDOMETER PICKUP KIT
Components needed to add pitot for speedometer gauges
150 4 Stroke Engines
For use with bulk pack speedometers. Includes pickup, misc. hardware and 20 ft.
(6.1 m) of tubing.
Priced & packaged in qty. of 24
US Quicksilver Product Guide
237