"Hi, need some assistance ,
"Hi, need some assistance , while flushing my motor I saw some hyd fluid comming from the trim piston on the stb side, salt water had rotted the inset screw in the top of the trim piston and cannot be put back in as the thread and everything has rotted away. So I have found a refurbed fastrac unit for my motor and was able to get the upper and lower pins loose, but my question is the electronocs connections, where to they disconnect? they loop up into the motor somewhere under in the botom, please please dont tell me I have to remove the entire power head to disconnect... has anyone ever replaced this type of hyd pump system and any tips,pics or proceedures would greatly appreciated. I have a seloc manual, but it gives crap inst on doing this part. Thanks in advance for anyones input"
"Hi, need some assistance , while flushing my motor I saw some hyd fluid comming from the trim piston on the stb side, salt water had rotted the inset screw in the top of the trim piston and cannot be put back in as the thread and everything has rotted away. So I have found a refurbed fastrac unit for my motor and was able to get the upper and lower pins loose, but my question is the electronocs connections, where to they disconnect? they loop up into the motor somewhere under in the botom, please please dont tell me I have to remove the entire power head to disconnect... has anyone ever replaced this type of hyd pump system and any tips,pics or proceedures would greatly appreciated. I have a seloc manual, but it gives crap inst on doing this part. Thanks in advance for anyones input"