Click for Volvo Penta parts and manuals!
Results 1 to 2 of 2
  1. #1

    Default Replacement Volvo out drive housing cover

    Total noob here, but I've got a boat with a significant crack to the outdrive
    upper gear housing cover (plastic piece like this https://marinepartssource.com/sx-upp...0aAvn9EALw_wcB)

    I have two questions:

    1) This looks like an easy piece to replace, am I correct?

    2) Is water intrusion into this area a problem while the cover is waiting to be replaced? I see a factory drain hole at the bottom of the cover, so I assume this wasnt meant to be water tight?

  2. #2
    Join Date
    Jun 2008
    Island Heights, NJ,

    Default Re: Replacement Volvo out drive housing cover

    Remove cover should just be a couple of bolts... If you look ar what is inside, you will likely find that the drive underneath the cover is always "wet".
    Capt Bob
    1969 23ft ChrisCraft Lancer
    Merc 5.7L 260HP/ Volvo 280

Similar Threads

  1. Replacement options/cost range for original 1991 Volvo AQ 740 A + drive
    By TechieTechie in forum Volvo Penta Gas Engine Forum
    Replies: 2
    Last Post: 05-03-2019, 03:13 PM
  2. Trouble mounting M340 bell housing to Volvo penta 270(B) flywheel cover?
    By dwade2777 in forum Chrysler Inboard and Sterndrive Forum
    Replies: 9
    Last Post: 07-14-2014, 09:49 PM
  3. Can't move water pump housing cover up drive shaft.
    By wassajet in forum Mercury Mariner Outboard Forum
    Replies: 0
    Last Post: 11-13-2013, 05:15 AM
  4. Bolt selection for flywheel cover and intermediate drive shaft housing
    By oldshore in forum Volvo Penta Gas Engine Forum
    Replies: 3
    Last Post: 05-23-2013, 07:19 PM
  5. Trouble seperating drive shaft housing from bell housing
    By starsh1p in forum Mercruiser Sterndrive Archive
    Replies: 14
    Last Post: 11-02-2008, 02:04 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts