Logo
FULL SITE MENU

Search results

  1. Jerryjerry05

    The fall

    Last week I found how far down the ground is. I tripped over a jack stand and landed on a Mercruiser lower unit and a electric scooter. I thought I broke my arm/shoulder. Nope, just scraped and bruised everywhere. Haven't been able to move good or at all. Younger, I would have bounced, not...
  2. Jerryjerry05

    1993 30 hp C30ELRR Hard shifting??

    Shifter is REALLLLY sticky not sticky but stuck. Need to really push/pull to make it move into gear. The gear box is ok and shifts good. It was just resealed. The shift handle will come off. Any tips or tricks? I hate to think I have to dismantle the motor to pull the shifter. This motor has...
  3. Jerryjerry05

    The STICKIES. What happened to the STICKIES????

    Open the site as usual and somethin look funni!!
  4. Jerryjerry05

    Here's a new one.

    2014 Yam115 4stroke. The aftermarket Sierra developed a pin hole leak and saturated the lower half of the motor, including the starter. Went to change the filter and clean the oil. Took the starter and all the electrical connections apart and reassembled everything. Went to start it and huge...
  5. Jerryjerry05

    No water from pee tube>>

    2003 Yam 200TXRB About 300 hrs. Motor starts and runs fine. No water from pee tube, even if taken loose at the rectifier. Tried weed eater string up in the rectifier and nothing. Should I try taking the rectifier apart? Owner says the impeller was changed last year??? Would this make the...
  6. Jerryjerry05

    2004 150 Yam buzzer going off.

    2004 Yam 150 carb.150TXRD The motor runs GREAT up to 3800-3900 and then the alarm starts. It's NOT overheating, I used a heat gun and checked the temps on each cylinder. Not getting anywhere's near hot. New water pump impeller. The owner replaced both oil sensors/senders in the tanks. Any...
  7. Jerryjerry05

    Yam 2006 225 4stroke runs bad for 15 min. then smooths out.

    Starts fine, runs bad for 10-15 min then when warm runs ok. Newer plugs, good comp 175-180# Won't accelerate without missing. Then when warm it smooths out and you can give it gas and it runs good. Started and pulled each plug wire and each cyl. would drop until the wire was replaced. No water...
  8. Jerryjerry05

    Ficht 150 max 2500 rpm

    Twin 150 Ficht, both only go to 2500 and then cut out. Any suggestions or ideas? Any other repair forums or places ? The only place in the treasure coast area keeps putting the owner off, first appointment was Jan 10 then next week and again next week. ANY HELP would be appreciated. The owner...
  9. Jerryjerry05

    Yamaha 2004 150 Oil problems???

    The motor runs great (mostely) , new impeller, thermo's,plugs,etc Running for about 1 mi. and then alarm sounds off and goes into limp mode(?) Back to idle and then it can be ran up again. Not overheating(tested) pretty sure the oil system is the problem. Cleaned both tanks and got the sludge...
  10. Jerryjerry05

    Ficht leaks fuel

    Johnson 150 Ficht. Not sure of the year??? # on the silver plug 4886732 As you(me) squeeze the bulb fuel squirts out the top cyl or hole for the top cyl. see pic by the #1 Big hole. What's behind there that lets fuel out? THANKS When you run it runs but not as good as the second motor.
  11. Jerryjerry05

    Changing ignition systems???

    Working on a 1994 25hp Mercury. Somewhere along the line I got some info that there might be an ignition change from the old SWITCHBOX ASSEMBLY *{(Jet 20)}* 18495A30 To SWITCHBOX ASSEMBLY *{(20/25) SN# USA-0G438000/BEL-9927000 Up}* 7452A19 Two different packs and I guess the trigger/stator...
  12. Jerryjerry05

    Tach not working

    1986 200 Mercury The wiring in the boat was a big ol pile of spaghetti!! I finally got all the wires back to where they were supposed to go( I think :) ) How do you check the motor to see if the signal to the tach is working? I turn the key and the digital readout (bottom face of the tach)comes...
  13. Jerryjerry05

    Mercury slowing down???

    1995 Mercury 75 hp. 17ft.Ranger Alum. bass boat. I don't know how to set the timing and don't have a manual for the motor. The motor seem to runs good and hitting on all 3 cyl, The linkage/throttle is advanced as far as it can go. Yet the most it gets is 4100 rpm's and 30mph. at wide open and...
  14. Jerryjerry05

    Oil recirc or fuel recirc lines diagrams

    I believe it's a 97 30hp.The ID tag's long gone The bottom of the intake is a tiny hose barb, I think it goes to a recirc oil hose, maybe it's recirc fuel line? Anyone have a diagram for the hoses on this motor? Thanks
  15. Jerryjerry05

    Lost free manual link

    Lost !! I lost the link to the free manuals on line. Can someone post it?
  16. Jerryjerry05

    2000 115 Johnson Transom clamp removal

    2000 115 Johnson. The clamps have been soaked in salt water for years. The snap rings were hard to remove(painted over) and the pins are frozen in place. I tried a propane torch to remove the tilt ram pin, didn't budge. I have a acetylene torch but want to make sure I'm not missing something? Is...
  17. Jerryjerry05

    High idle

    1996 200 Evinrude.Carb model. Serial #E200TXEDR The comp is good, good spark. The rpm's at idle are 2-3k if not more. The linkage is set so the throttle pickup point is open. It won't go anywhere to let the idle down. How/what do I do to bring the idle down? Seems as though there's a new...
  18. Jerryjerry05

    2010 115TLR 4Stroke.

    2010 115 TLR 4st. How do you pressure test the high pressure pump in the VST? It does't have a Schrader valve? Thanks, Jerry From what I can research, I'd need to get a...
  19. Jerryjerry05

    98 30hp Mercury

    98 30 hp on a 16 ft. alum. Jon boat. Bass Tracker What size prop should I get? I know how to test once I get a prop that might be close.. THANKS!!
  20. Jerryjerry05

    Yamaha 1154st. limp mode

    Yamaha 115 4 stroke. 2001 Turn the key on and an alarm comes on and doesn't go away. Not over heated. Cold motor. New impeller. Starts but goes into limp mode?? what to check?
Back
Top