Logo
FULL SITE MENU

Search results

  1. N

    1993 Johnson 115 VJ115TLETS locking up. HELP

    Pump won’t hold pressure. Dunked it and found it blowing bubbles out of this crack…
  2. N

    1993 Johnson 115 VJ115TLETS locking up. HELP

    Cyl 1 starboard top 125 Cyl 2 port top 110 Cyl 3 starboard bottom 130 Cyl 4 port bottom 120
  3. N

    1993 Johnson 115 VJ115TLETS locking up. HELP

    The Cyl 1 starboard top 125 Cyl 2 port top 110 Cyl 3 starboard bottom 130 Cyl 4 port bottom 120
  4. N

    1993 Johnson 115 VJ115TLETS locking up. HELP

    correct. What did confuse me was setting float drop. I believe I may have set it so the float so the float literally dropped 1 1/8 from casting surface to top of the float (so not including float thickness) instead of measuring from casting surface to the bottom of the float (so including float...
  5. N

    1993 Johnson 115 VJ115TLETS locking up. HELP

    Can someone recommend a fuel pump conversion kit for this motor? I’d like to delete the vro.
  6. N

    1993 Johnson 115 VJ115TLETS locking up. HELP

    What kind of fuel pressure should I be looking for? Idle vs. wide open? Max pressure drop? I did have to sand down both of the carb bowls due to warpage. My float drop may have been set to too much drop. Motor still starts and idles around good.
  7. N

    1993 Johnson 115 VJ115TLETS locking up. HELP

    I have a 93 Johnson 115 cross flow. Recently the only way it would run is if I bumped the “choke”. I pulled the carbs and cleaned them, replaced the gaskets and needle and seat. Did a link and sync, joe reeves method WOT timing and now if I run 4000 + rpm’s for a short time, the engine locks up...
Back
Top