Logo
FULL SITE MENU

Search results

  1. C

    Water in oil

    I have heard of no other issues with Barr products. I think it’s probably 1 in 100000. I just had some bad luck
  2. C

    Water in oil

    Barr.
  3. C

    Water in oil

    Oh yes. We put new risers and manifolds both sides. The one that we installed on stbd side had two holes in it(new) sent it back and received another new one, installed and no issues
  4. C

    Water in oil

    I changed the gasket on the port side and pulled the plugs out. No water in cylinders. Do you suspect that riser could leak as well?
  5. C

    Water in oil

    It seems the gaskets were ok. Water was coming from the a hole in the riser water jacket. Got a new riser and changed the oil two more time seems ok. Not sure if it will last but it’s working now
  6. C

    Water in oil

    Well I found the problem. The block off gasket on the stbd side failed on the top where raw water enters the riser. Seems like the permeates high heat optimum silicone gasket maker reacts with the rubber on the gasket. It only failed on the raw water side not on the bottom (antifreeze...
  7. C

    Water in oil

    Raw water in crank case is new. It seemed like a pretty straight fwd install
  8. C

    Water in oil

    Yes the water in crank case happened I assume when we started it after we installed new risers
  9. C

    Water in oil

    Thanks. I’m going to take them off on Monday inspect install and risers
  10. C

    Water in oil

    Excuse me for my lack of knowledge. exhaust is raw water. Engine has antifreeze
  11. C

    Water in oil

    I have a 2013 mercruiser 383 stroker and have changed the exhaust manifold and exhaust risers. Started engine with fresh water to check for leaks. All good from the outside launched the boat and ran about 40 minutes and found oil level 2 quarts over full. Antifreeze at normal level. Plumbing is...
Back
Top