Logo

Search results

  1. 1

    Johnson 115ph 1990

    That sir, I can do
  2. 1

    Johnson 115ph 1990

    I say good spark but I don't have an online tester, can I just gap a plug to 3/8 and ground it and fire and see if it sparks?
  3. 1

    Johnson 115ph 1990

    Good spark, have not tested on new tank but interesting you say that because I tried to put gas in it this weekend and it shot back out at me. Runs the same with cowling on and off, and flywheel key is good, I just changed the rectifier so I got a good look at it. I'm going to take it out today...
  4. 1

    Johnson 115ph 1990

    Could be, it's one from harbor freight.
  5. 1

    Johnson 115ph 1990

    So it would have to be rings right? You think 90 is too low?
  6. 1

    Johnson 115ph 1990

    Ok, thanks for telling me that's what I was leaning too. I thought maybe they was broke or bent and letting pressure back out into the carbs.
  7. 1

    Johnson 115ph 1990

    I just looked it up, that seems pretty easy. I'm going to order new gaskets so when I pull it, I'll have them and I'll post a picture of what I see. I just watched a video and a guy said his messed up because it over heated. I think the guy I bought it from dry fired it for awhile maybe because...
  8. 1

    Johnson 115ph 1990

    It is setting right at the notch on the bar
  9. 1

    Johnson 115ph 1990

    IS that where the reeds set? I'll look into it and see if that's something I can do. I know I can figure it out. I've pulled the flywheel and changed the rectifier myself and I have the manual. I'll get back with you for sure.
  10. 1

    Johnson 115ph 1990

    I got them gapped to .03 but looking at them today they had some oil on them... wet oil. So I cleaned em and made sure the Gap was right.. ish... and went out. Launched, no issues... fished after I disconnected the tank and let it idle everything out of the carbs and lines... waited about an...
  11. 1

    Johnson 115ph 1990

    It hits a couple times and sneezes.. or it will turn over and start for a second but doesn't sound like it's all there. How would someone check something like that? I noticed today that the plugs had a little oil on them. So I'm thinking the primer silonoid is leaking as it sets and floods it...
  12. 1

    Johnson 115ph 1990

    90 psi on each
  13. 1

    Johnson 115ph 1990

    Issue is the motor runs fine when I first put it in the water, runs great idle sucks but I adjust the throttle and I do ok. When i shut it off to fish awhile I csnt get it started again and when it does there is NO POWER. I'll point at the sky for 4 minutes before it slowly picks back up. Once...
  14. 1

    1990 115 4v

    Man I wish I knew the answers, I saved up for this boat forever and can't really afford to take it to the shop. I got the manual coming soon, I gotta figure this out. But here's what I got.. Haven't checked compression during its episodes... once I get it out the eater it's fine but I'll try...
  15. 1

    1990 115 4v

    Im about to loose my mind. Motor at the beginning of the day runs absolutely fine. Wide open is great everything is great. But when I shut it off and fish for just a few minutes the motor won't idle. It will start but sounds terrible.. like it's bubbling under water ( not the normal sound) and...
Back
Top