Logo
FULL SITE MENU

Search results

  1. T

    1996 evinrude 150 - use any sealer around water passages on heads?

    hey guys, I have been a long time user of this incredible forum to troubleshoot every issue over the last many years on my 1996 Evinrude 150 OceanPro (Looper). I am getting ready to pop the heads off, I have new o-rings, but was curious is there a recommended "sealer" to use around the water...
  2. T

    1996 Evinrude 150 No Oil Light after VRO pumped rebuild

    Howdy all! Thanks to all of you I have kept my 1996 Evinrude 150 on the water! And now a new issue has come up, one I have never seen before. backstory-> I noticed my oil consumption was way off. Burning through a gallon of oil every 10-15 gallons of fuel. Way too high as it should be 50 to...
  3. T

    1996 Evinrude 150 runs perfect, doesn’t charge

    After running well since replacing the power pack early this year I noticed today that my Volts were not going up to the charging range while running. Not great. Pull the stator to visually inspect and test the Orange/Orange blk wires. Getting 54 ohms. I don’t believe rectifier is having issue...
  4. T

    1996 Evinrude 150 (Looper) - Dies on acceleration

    Howdy folks, It's been a while since my last post because my engine has been running great! That is until a few weeks backs it started doing some crazy dance at speed, losing power, then running fine and then barely letting me accelerate. Mind you this was after a full day of running fine. Then...
  5. T

    '96 Evinrude 150 OceanPro - Starting issues

    Have had this 1996 Evinrude 150 Ocean Pro since new. It sat for many years and then I decided to revive it back in 2016. Cleaned carbs, replaced lines, and so on. Ran great all summer 2016, always hard to start cold but just assumed that was part of it. This summer has been a bit different. The...
  6. T

    1995 Evinrude Ocean Pro 150 bogging/power loss after 30 min of running

    Hey Guys, New to the forum and didn't see this specific issue when searching. I have a 1995 Evinrude Ocean Pro "Looper" 150. Used to run very strong with no issue, then it sat for 4 years. Prior to running it I did the following: * Sea foam, quite a bit * new fuel lines from fuel filter to...
Back
Top