Logo

Search:

Type: Posts; User: bondo

Page 1 of 4 1 2 3 4

Search: Search took 0.08 seconds.

  1. Replies
    2
    Views
    9

    Re: Boat cover for semi-v

    Ayuh,..... At yer local custom canvas shop,.....
  2. Replies
    3
    Views
    36

    Re: 1987 4.3 OMC Alternator with 1 Wire Issue

    Ayuh,..... There should be purple wires in the harness, which is the ignition circuit,....
  3. Replies
    2
    Views
    27

    Re: 3.0 OMC Will run and die right after

    Ayuh,..... It sounds like the key switch is supplin' voltage to the ignition, in the Start position, but droppin' the voltage in the run position,......

    The ignition circuit is the purple...
  4. Re: Default HELP in finding a short causing no start to diesel

    Ayuh,.... You need to trace the start circuit, 'n only the start circuit, which should be yellow/ red wires from the key switch, through the safety switch in the controller, to the slave solenoid,...
  5. Thread: alarm on Triton

    by bondo
    Replies
    3
    Views
    60

    Re: alarm on Triton

    Ayuh,.... Those sensors,.... unplug one, 'n try it,.... then the same for the other,.....

    No phone numbers, unless you love spam calls,....
  6. Replies
    2
    Views
    79

    Re: Custom Steering Cable - Who Makes Them??

    Ayuh,..... What drive,..??

    If it's an ole Stringer, ya might be SOL,....
    For anything else, ya might need to replace abit more than just the cable,......
  7. Thread: Help with wiring

    by bondo
    Replies
    4
    Views
    51

    Re: Help with wiring

    Ayuh,.... It should be at, or in-line with an aft facin' hull vent,.....
  8. Thread: alarm on Triton

    by bondo
    Replies
    3
    Views
    60

    Re: alarm on Triton

    Ayuh,.... Just unplug the sensor, 'n the alarm should stop,.....

    They work by goin' to ground, to sound the alarm,....
  9. Replies
    1
    Views
    59

    Re: Can anyone please ID this engine?

    Ayuh,.... Without some numbers, the best I can tell ya is that it's a SBC based motor,.....
    Could be a 283, or a 327, or a 305, dependin' on the vintage,.....
  10. Replies
    3
    Views
    513

    Re: No water flow OMC Stringer

    Ayuh,..... Impeller pumps will not suck, they are a flooded entry pump, which means the pump itself, not just the inlet Must be underwater,......
  11. Thread: Help with wiring

    by bondo
    Replies
    4
    Views
    51

    Re: Help with wiring

    Ayuh,..... Black wires are most likely/ should be Grounds,.....
  12. Re: Shift interrupter stalling motor whenever shifting into gear??

    Ayuh,...... Or just replace the lower cable,......

    The inner cable wears a groove in the outer casing, causin' slop, 'n binding,.....

    Probably oughta replace all the rubber parts, bellows,...
  13. Re: Shift interrupter stalling motor whenever shifting into gear??

    Ayuh,..... The odds are 'bout 90% that it's the lower shift cable, but inspect the rest of the linkages too,......

    The switch should Not move, unless In the water, comin' Outa gear,....
  14. Replies
    3
    Views
    79

    Re: Exhaust manifold compatibility

    Ayuh,..... Should be no problem there,.....

    Test the current prop 1st, then decide,....
  15. Re: High oil pressure on startup, then comes down to normal

    Ayuh,..... We're in the Omc forum, so I assume this is an Omc powered barge,....??......

    If so,..... Listen to louc,.... Don't walk, Run away from it,....

    Omc has been outa business...
  16. Re: 1989 mod. AQ271C - Releasing it's power potensial, what do I do?

    Ayuh,..... Horsepower in boats is dollars,. squared,.....

    The 383 stroker, built to build big torque, from idle to 5,000 rpms is a boat motor,.....

    The dart block build, with a huge cam, 'n...
  17. Replies
    5
    Views
    80

    Re: 1985 130 hour mercruiser

    Ayuh,..... That's the water side of the block, the oil side has the distributor,.....
    No oil in either manifold,....

    My guess is yer seein' oil from the crankcase vent to the carb hose, or the...
  18. Re: Identifying current motor by engraved Block ID

    Ayuh,.... The 3.0l is a GM block, the 2.3l is a Ford block,....
  19. Thread: float switch

    by bondo
    Replies
    2
    Views
    58

    Re: float switch

    Ayuh,.... Float switches are simple make, or break switches,.... No run-on when shut off,.....

    If it's leavin' to much water in the bilge, reposition it to stay on longer,.....
  20. Replies
    1
    Views
    40

    Re: Yamaha L4 3.0 stalls when placed in gear

    Ayuh,.... Check yer thread at iboats,....
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4