Logo

Search:

Type: Posts; User: Docksidemarineservices

Page 1 of 4 1 2 3 4

Search: Search took 0.04 seconds.

  1. Re: 2006 Mercruiser 8.1 Horizon S MIE Single point drain question...

    The hose comes out clean the collet stays with the air valve... The hoses not being hooked up will not cause a leak.
  2. Re: 2006 Mercruiser 8.1 Horizon S MIE Single point drain question...

    You push the tube in hold the collet down and pull the tube out.

    Once you get everything back together. Take the blue hand pump and throw it into the trash can. If you use the drain system the Air...
  3. Re: V4 motor has no power with cowling on, runs fine with it off

    OEM work best.
  4. Re: V4 motor has no power with cowling on, runs fine with it off

    Change the plug wires.
  5. Replies
    5
    Views
    46

    Re: Additional oil tank ?

    That is a Quick Silver flush attachment.... There is a special fitting you attach to the hose that plugs into it.
  6. Replies
    10
    Views
    105

    Re: High oil PSI

    Quick silver 25/40 oil.... Everyone has their own opinion.... I run this in my Pro Street car with a Blown SBC....
  7. Re: Oil leak on brand new 300HP Verado - dissapointed is an understatement

    All new engine pass oil until they are broken in and the rings are seated.... Put some hours on it.
  8. Re: Best spark plug 350 Mercruiser Mag

    The OEM plugs.
  9. Re: 1987 Mercury 25XD spins out with load

    If you are getting to half throttle it is probably not the hub... More like cavitation.
  10. Replies
    5
    Views
    90

    Re: The best 2 stoke oil!?!?

    Merc Premium plus for max engine life in your Mercury engine.
  11. Replies
    12
    Views
    1,114

    Re: VRO Pump

    I guess you should have asked an actual Marine engine mechanic.... Then you would have been advised to replace the VRO if needed and run the system as designed.
  12. Re: 1992 Mercruiser 4.3L spitting through carb

    The only way you would notice sideways movement is if you pulled the dist and actually checked it.... Did you do that?
  13. Re: 1992 Mercruiser 4.3L spitting through carb

    Did you replace the pick up in the distributor? Did you look for side ways movement in the distributor shaft?
  14. Re: BF225A4 - Mid-Shaft Bushing Destroyed but No Damage to Mid-section?

    I have serviced multiple 225's over the years that have had the bushing removed with no ill effects....
  15. Re: Pressurizing the 3 gal oil tank

    Pull the tank, rig up short lines and make sure the tank is sealed... If it works the problem is with the install.
  16. Replies
    4
    Views
    74

    Re: Bravo 3 squeak/rattle

    Bravo's make noise in neutral.... Shift it into gear and the noise will disappear... Run it.
  17. Re: Scraping sound when running

    Read this.... Sounds familiar..... Just read towards the end of the thread and what the fix was.....
    ...
  18. Replies
    6
    Views
    99

    Re: Yamaha Oil Pump

    You think Red is bad.... Try getting the Green apart. Its like 5200.
  19. Replies
    6
    Views
    99

    Re: Yamaha Oil Pump

    Clean both surfaces and use green locktite 648 and push it back in.
  20. Re: 1981 3.0l merc stern drive

    I am assuming you found a newer Alpha and want to hang it behind your 3.0......

    Well unless you change out the transom assembly that will not be happening.....

    Also, the gear ratio for a 3.0...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4