Logo

Search:

Type: Posts; User: faztbullet

Page 1 of 4 1 2 3 4

Search: Search took 0.03 seconds.

  1. Replies
    5
    Views
    45

    Re: 90-WME-62 carb threaded hole empty?

    There is a difference as some HP have em and some dont.
  2. Re: Taco stopped all of a sudden while under power

    That the control module.. the rect/reg's is mounted between spark plug bank. looks like below and there is 2 of them

    http://www.marineengine.com/parts/images/mercury/883072T2.jpg
  3. Replies
    5
    Views
    45

    Re: 90-WME-62 carb threaded hole empty?

    That is the fuel bowl vent...depending on HP some have jets .
  4. Re: Taco stopped all of a sudden while under power

    Either lost signal thru bad connection or rect/regulator took a dump
  5. Replies
    5
    Views
    77

    Re: Crank seal rings

    Outer radius only
  6. Re: 98 Johnson 200 oceanrunner trim down, not up

    Number 93 ---limit switch..
    26806
  7. Re: johnson 1994 150hp ocean runner fuel pouring out of front of carburetors

    The plastic could be cracked when inlets seat screws in..fuel would bypass needle inlet.
  8. Replies
    5
    Views
    70

    Re: 1998 J115pleem start issues

    You cannot load test battery with multimeter..
  9. Re: 1992 Johnson 150hp Fast Strike only runs half speed.

    100 psi is about normal on a 60 as it has decompression ports to assist in smooth idle and starting RPM. Sounds like a stator or pack dropping a bank of cylinders.
  10. Re: 1995 130HP Johnson 2 Stroke shutting down

    Need to inspect your carb work, the gaskets and mounting o-rings. Make sure floats are set correctly and not upside down.
  11. Re: 2005 Johnson 150 (J150PLSOE) will not pass 5MPH. See Video!

    Yes, no and no..
    Disconnect the shift switch and retest. Need to test spark also as its not running on all 6 cylinders. Rev limiter not activated till 6800 RPM and it doesnt look to be in SLOW mode...
  12. Re: 2005 Johnson 150 (J150PLSOE) will not pass 5MPH. See Video!

    Keep reving it up like that with no load and you will pop the skirt/s on piston
  13. Replies
    5
    Views
    82

    Re: Additional oil tank ?

    Flushing attachment
  14. Replies
    2
    Views
    119

    Re: Johnson 150 Faststrike Lower Unit

    The 306B unit will work with correct driveshaft. Your driveshaft assembly can be removed and cross pin removed, and installed into replacement unit. You shaft should have 339062 etched into it. If...
  15. Replies
    1
    Views
    78

    Re: Rattle when throttling off

    Keep reving it with no load and motor will open the emergency inspection port on ya. motor will rattle at no load and high RPM ..1500-2000 max rev at no load
  16. Replies
    18
    Views
    301

    Re: Which pistons?

    Wiseco ring will not fit OEM piston !!!!!!
  17. Replies
    12
    Views
    193

    Re: Reversed Battery Leads

    A Opti V-6 will have a alternator similar to a automotive style...OP has a 40 HP motor
  18. Replies
    18
    Views
    301

    Re: Which pistons?

    Its the piston that starts failure. All rings are pressure backed rings, when coke builds behind ring the ring tension is increased and the ring starts to flutter wearing the piston land. This then...
  19. Replies
    12
    Views
    193

    Re: Reversed Battery Leads

    You do not have a alternator,,,you have a stator that feeds a rect/regulator. A stator has no diodes.
  20. Replies
    5
    Views
    103

    Re: Starting Circuit Diode

    This is known as a blocking or quenching diode.
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4