Logo

Search:

Type: Posts; User: daves69

Page 1 of 4 1 2 3 4

Search: Search took 0.01 seconds.

  1. Re: Glastron GT185 4.3 Liter Rev Limiter Top Speed issue

    FWIW, The best my 2300 Holley equipped 2008 Glastron GT185 4.3 has been 54 mph per gps on flat water.
    27114
  2. Replies
    3
    Views
    63

    Re: Volvo Penta Stumbles under load.

    Are the plug wires good? Have you checked resistance on them? Are they on the proper plug in the proper sequence?
  3. Re: Volvo Penta 4.3 binding when trying to start

    What does the oil look like?

    Will it rotate by hand or starter with the plugs out?
  4. Replies
    1
    Views
    105

    Re: Minn Kota Endurance C2 55 thrust

    IMO, it should have been opened up cleaned and dried out ASAP after being submerged as corrosion possibility likely. I think I would still tear it down to assess issues before throwing seal and...
  5. Replies
    5
    Views
    183

    Re: Manifold Crack in Volvo 4.3 GXI

    If they couldn't even remove the drain plugs on the manifolds, I'd be concerned with the engine block as well!

    FWIW, plugging is a repair option for cast iron depending on you situation............
  6. Replies
    2
    Views
    173

    Re: 360 harmonic balancer diameter?

    I believe it's 7-1/4"
    1/16 = 1

    BTW, mark the inner ring to correspond with the verified TDC of the outer for a visual reference of any "slippage" on these older dampers.
  7. Re: Chrysler 360 Losing coolant and puffing white smoke

    Pull the plugs, suspect the one that looks different, check that cylinder compression.
  8. Re: OEM specs for ORIGINAL Chrysler Marine 440 Camshaft

    I think I'd draft a form letter and send it to several cam grind companies to their tech support. I would think they have the specs if they grind replacements. Other than that one could indicate the...
  9. Thread: Steering cable

    by daves69
    Replies
    2
    Views
    267

    Re: Steering cable

    FWIW, My old boat had a transom swivel / cable setup. The '57 Scott-McColloch 75 Hp had no problem when tilting.
    I was able to use that same cable through the tube on the 90 Hp Chrysler I bought. ...
  10. Re: need help with transom mount part no for motor guide

    ......
    MotorGuide Trolling Motor Parts | OEM Mercury Parts | Boats.net
  11. Replies
    6
    Views
    286

    Re: Outboard Motor Cowling Sound Blanket

    You might try Eastwood or similar suppliers. They offer a variety sound/insulating products.

    Automotive Sound Deadening, Soundproofing - Eastwood
  12. Replies
    6
    Views
    371

    Re: 1972 55hp Chrysler Tachometer

    Choose your poles.............
    New Stewart-Warner 8000 rpm tachometer black bezel, street rod, rat rod, marine | eBay
  13. Replies
    11
    Views
    898

    Re: Replacing Prestolite distributor?

    You might verify all connections are sound. The Mopar pickup and harness have been known to fail.
    The below link describes a simple check. Two items prior to trying you might note.
    1) Mark your...
  14. Re: 2003 4.3GXi-C will not plane... but runs fine when it finally does

    Not that this is the problem but you might want to investigate your prop for slippage on the hub for time to plane increases.


    https://youtu.be/-N_vK9UoVvk?t=120


    ...
  15. Replies
    3
    Views
    1,178

    Re: 1977 Chrysler 360 cuts out at 2500 RPM's

    Sounds like you threw all the usual electronic suspects into it.
    Pickup screen or filter clogged?
    Fuel pump not recovering it's stroke at higher RPM?
    Worn out pump cam?
    Old hose collapsed...
  16. Replies
    3
    Views
    998

    Re: Main and rod bearings marks

    See the video here............
    https://www.dragzine.com/news/video-mahle-talks-markings-on-engine-bearings/
  17. Re: Chrysler M440 Leaking Water out of the flywheel Port

    a link that may help........

    https://www.forabodiesonly.com/mopar/ams/how-to-fix-a-cracked-block-easy-also.264/
  18. Re: Chrysler M440 Leaking Water out of the flywheel Port

    Just a cam plug and two oil gallery plugs on this '68 440 automotive block. Not sure a marine block is any different.......

    24263
  19. Replies
    11
    Views
    1,288

    Re: Chrysler 440 1978 - ignition problem

    This FREE FSM download link is for small blocks (LM318-LM360). I believe the ECU part is basically if not even the same for an rb M440. There is also an older 440 manual available there but I don't...
  20. Replies
    11
    Views
    1,288

    Re: Chrysler 440 1978 - ignition problem

    FWIW, Just the fact it leached out doesn't necessarily qualify it as a failed unit electronically. These ECMs have been known to do that. I have one that was in a box with another on a shelf for...
Results 1 to 20 of 70
Page 1 of 4 1 2 3 4