Logo

MERCURY 60 4 STROKE 1C453840, when you travel 3000-4000rpms for about 5-10 minutes it boogs down for 20 seconds to a neutral state the operates normal

Robertse

New member
Hi Re MERCURY 60 4 STROKE 1C453840, when you travel 3000-4000rpms for about 5-10 minutes it boogs down for 20 seconds to a neutral state the operates normal again.

I have replaced the fuel lines, bulb, cleaned the VST, replaced fuel regulator , High Pressure Fuel Pump, the motor is not overheating there is no alarm triggered and it has not resolved the issue, also ideas will be appreciated.
 
The fact that it comes back on its own is the tell. Twenty seconds is about how long the VST takes to refill once the engine drops down to an idle. So the level is running low, the high pressure pump starts pulling air, rpm falls, demand drops, the level catches back up... and away you go again.

That puts the problem on the low pressure side, not the rail. You have done the pump, the regulator and the VST. What is left is everything that feeds the VST.

Where does the fuel come off the tank? A lot of hulls have an anti siphon valve right at the fitting, a spring and ball inside a hose barb. It gets sticky with age and it will pass at cruise and starve at 3500. Check the tank vent while you are there. A plugged vent pulls the tank negative and the pump loses its suction after a few minutes of steady running. Crack the fill cap next time it does it. If the bog goes away, that is your answer.

Was there an inline water separating filter you did not mention? A half blocked element behaves exactly like this, and it is the cheapest thing on the list to rule out.

The other spot is the small screen at the VST inlet, behind the needle seat. Everybody cleans out the tank and misses that screen. If it is half lacquered the float bowl cannot keep up at 3500, but it will idle all day.

The test I would do. Tee a gauge into the low pressure hose just ahead of the VST, tape it where you can see it, and run until it bogs. If the low side falls off when it happens, the rail pressure is only following it down and you are chasing the wrong end of the boat.

Watch the primer bulb too. If it gets sucked flat that is a restriction, not a pump. And squeeze it while it is bogging. If the engine picks straight back up, you know the VST was empty.

I could be wrong. A coil breaking down hot can feel similar. But they rarely recover that cleanly on their own. When you say neutral state, does it drop to idle rpm, or does it keep running and just will not pull? thanks
 
Back
Top