Logo

changed inpella on 25hp two storke now having gear shifter problems

wonnie

New member
hi
i am having problems after undoing the gear selector rod on my 25 hp two stroke
changed the impel la and that was no problem but when i reconnect the gear linkage now have selector problem with the forward control selector when i put it in to nutral the prop is still spinning and i have to move the selector into the nearly the revers position before its in nutral
also i have a clicking sound that some time comes when i do this it sounds like the dog clutch is ingauging
i have ajusted the selector rod thinking that that is some what out of adjustment but thats not working i have looked at the linkage that connect to the gear selector that come from the forward controls but that out of adjustment and to get it in the right place i have run out of thread on the fitting that comes of the cable to the leaver arm of the gear box selector
i am at a lose as to what i have done wrong as it was working quite fine until i disconnected it and reconnected it
there must be some ajustment that i have done or not done that has made it so
please cane some one help
 
Slowly turn the UPPER nut till shift rod seperates .-----Operate lever to lift the shift rod.-----Turn upper nut down 2 turns -----Bring upper rod down to engage lower thread rod an tighten.
 
thanks i will give it a try
ok so u=i have done that and then i found out that i had not put the motor in revers e when i put it back to gether
this as u can emagen was the problem as this is the first time i have worked on this motor i guse u could say its a beginner problem but being me i think i was not thinking at the time and in to much of a hurry to get it going again
thanks for the advise i received
 
Any way you could post a picture of where the shift rod linkage connects to the rod itself. While dropping the lower unit the rod popped out of its spot and im having trouble identifying how it mounts back into the bracket
 
Back
Top