1997 Johnson 130 V4 Looper Idle

[pspagna]

I am looking for some guidance on increasing the idle a little on my Johnson 130. It is currently idling very low so much so that when I put it in gear it will die. If I put it in gear quick and idle up fast boat performs fine. I just need it bumped a little on the rpm when in neutral. I cannot find anything online as to what screw to adjust. There are some many on the linkage and then there is a idle timing screw and WOT timing screw that I don't want to touch. If anyone has experinence with this or a picture of which screw I can adjust to bump idle a little it would be much appreciated. Thanks so much!

 

[Jcb150faststrike]

Looking for help on my Johnson 150 fast strike outboard 1996 model

 

[Jcb150faststrike]

This is what I see when I look in my manual tilt trim hydraulic No flat head screw to loosen

 

[racerone]

Do you need help lifting it off the boat ???----Or what is your motor doing / not doing ?

 

[Jcb150faststrike]

The battery is completely dead. The boat has been setting for a long time with the keg on the ground and I’m trying to use the manual release on the left side of the engine and when I look in the hole, I don’t see a flathead screw to twist like everything talks about online

 

[Jcb150faststrike]

 

[Jcb150faststrike]

This is what I see

 

[Jcb150faststrike]

Do you need help lifting it off the boat ???----Or what is your motor doing / not doing ?

Do you need help lifting it off the boat ???----Or what is your motor doing / not doing ?

 

[Jcb150faststrike]

The battery is completely dead. The boat has been setting for a long time with the skeg on the ground and I’m trying to use the manual release on the left side of the engine and when I look in the hole, I don’t see a flathead screw to twist like everything talks about online.