Logo

Evinrude E-Tec 90 HP Trim and Tilt

Rory Livingston

New member
Hi. I need to top up the Trim and Tilt fluid level but can't locate the fill point. I removed a bolt (fluid came out) but I don't believe this is the fill point as it is low on the unit. I am not the most mechanical but will give it a go. any help appreciated as I can't find video on Youtube specific to Evinrude motors
 
Tilt the engine all the way up,it's a plug in the resevoir next to the cylinder that you need a straight screwdriver to remove.Fill untill the fluid runs out of the hole.
 
Tilt the engine all the way up,it's a plug in the resevoir next to the cylinder that you need a straight screwdriver to remove.Fill untill the fluid runs out of the hole.
thank you. only problem is that the screw sits behind the motor bracket......I can't access it without taking out the whole unit.....very weird
 
thank you. only problem is that the screw sits behind the motor bracket......I can't access it without taking out the whole unit.....very weird
My 2006 75 is the same way. You need to use the engine brace to support the motor tilted up and then remove the pin that attaches the trim cylinder to the motor. You can then rock the trim unit forward to get acess to the screw. Pretty messed up since you need to re-attach it and work it up and down to bleed air out. Rinse and repeat.
 
Back
Top