Logo
FULL SITE MENU

Recent content by trx125

  1. T

    BF130 carbon treatment results

    I just finished off the first carbon treatment in about 4 years. I replaced the head/head gasket in '17 after replacement and carbon treatment I had 209-207 psi across all cylinders. But every boating season since then it seemed as if the compression dropped off 5-7psi across all cylinders and...
  2. T

    BF130 sucking/hissing sound

    When I run the engine and after shutting it down, I get a sucking/swoosh sound through the intake for a couple seconds. It sounds like crankcase pressure being released after shutdown. PVC valve clogged, breather element clogged, any ideas on why this happens or is it just a normal occurrence...
  3. T

    BF130 vertical shaft bushing

    Does the 25" BF130 have a vertical shaft bushing avaliable? I've looked on all the parts diagrams but I can't find one. I'm getting a whining noise in the mid section only at idle. When in gear the whining in non-exsistent. Any thoughts or advice on this is welcome. Thanks.
  4. T

    225 tilt trim plug?

    I need the female plug that goes on the wiring harness for the tilt trim switch inside the motor cowling. The switch stuck and the motor came down and continued running and overheated the plug and burn one of the female pins inside the plug. I need the female plug so I can splice the plug back...
  5. T

    interchangable parts

    I'm looking a new set of valves. I can by the separate oem valves from Honda for $30(intake) and $45(exhaust) or I can get an oem set for an Accord that are the exact same part numbers for $175-200 per set. So is there really any difference, they have the exact same specs and part # for both...
  6. T

    Cleaning headgasket material

    What is a good way to clean the gasket material off the block for a head gasket replacement?
  7. T

    bf130 cylinder head

    I need to order a cylinder head and replace a couple valves to repair my engine. This is the part I'm looking to order. The ? I have is does this head sub assembly come with the valve guides installed or will I need to order new guides and have them installed. Thanks. Cylinder head sub assy(no...
  8. T

    Honda 130 Balancer ?

    Is the intake balancer belt pulley press fit onto the shaft? If so, does it press on the shaft until it is flush with the end of the shaft? Thanks. My pulley has walked off the shaft and torn up the belt and worn a hole thru the timing cover. I purchased this engine used and the service history...
See more
Back
Top